Abstract:The composite crossarm insulator differs greatly from the suspension insulator in structure and arrangement. This study aims to determine the pollution flashover characteristics of composite crossarm insulators under different voltage grades. Four types of AC composite crossarm insulators with diameters ranging from 100 mm to 450 mm are subjected to artificial pollution test, and then the effects of the surface hydrophobicity state of silicone rubber, core diameter, umbrella structure, arrangement, and insulation distance on the pollution flashover voltage of the composite crossarm insulators are analyzed. Under the pollution grade 0.2/1.0 mg/cm2 and voltage grade from 66 kV to 1000 kV, if the silicone rubber surface changes from HC5 to HC6, the pollution flashover voltage of the composite crossarm insulator will increase by 13.5% to 21.0% compared with the hydrophilic surface. If the core diameter changes from 100 mm to 300 mm, the pollution flashover voltage gradient decreases with the increase in core diameter; if the core diameter changes from 300 mm to 450 mm, the pollution flashover voltage gradient increases with core diameter. Under the same insulation height and core diameter, the umbrella structure will have a certain impact on pollution flashover voltage by up to 1.7% to 5.4%. Under the horizontal arrangement, the pollution flashover voltage can increase by 10.5% to 12.1% compared with that under the vertical arrangement. Under the hydrophilic surface and weak hydrophobicity state, the pollution flashover voltage has a linear relationship with the insulation distance. The above results can provide a reference for the structural design and optimization of the composite crossarm insulator.

Influence of Kieselguhr Characteristics on Artificial Pollution Test of Composite Insulators

Study on the Transference of Hydroplibocity for Kaolin and Kieselgur

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Influence of Ambient Humidity on Hydrophobicity Transfer of Silicone Rubber Material

Artificial pollution test and pollution performance of composite insulators

Influence Factors of Hydrophobicity and DC Flashover Performance for Composite Insulators

Analysis on Effect of Hydrophobicity on Anti-pollution Flashover Performance of Line Insulators

Test Method of DC Artificial Contaminated Composite Insulators

Laboratory study on hydrophobicity and pollution flashover properties of polymer insulators

Characteristics of Small-Molecule Migration of Silicone Rubber Insulator in Electrical Power Systems

Influence of Environmental Temperature on Flashover Voltage of Composite Insulator

The Effect of Powdered Layer on the Physicochemical Properties of Silicone Rubber Surface

Influence of Tower Anticorrosion Coating As Contaminant on Operation Characteristics of Composite Insulator

Pollution Flashover Characteristics of Composite Crossarm Insulator with a Large Diameter

Influence of Environmental Factors on Hydrophobicity Transfer Property of Silicone Rubber Material

Investigation on Hydrophobicity and Pollution Status of Composite Insulators in Contaminated Areas

Analysis of characteristic of natural pollution test and artificial simulation method

Research on the Material and Pollution-Flashover Properties of Hard Composite Insulators

Flashover Characteristic of Polluted Silicone Rubber with Different Hydrophobicity

Flashover Performance of Pre-contaminated and Ice-covered Composite Insulators to be Used in 1000 kV UHV AC Transmission Lines

Natural Pollution Test of Composite and Porcelain Insulators Under AC and DC Stress