Abstract:In large area micro hot embossing, the process temperature plays a critical role to both the local fidelity of microstructure formation and global uniformity. The significance of low temperature hot embossing is to improve global flatness of embossed devices. This paper reports on experimental studies of polymer deformation and relaxation in micro embossing when the process temperatures are below or near its glass transition temperature (Tg). In this investigation, an indentation system and a micro embosser were used to investigate the relationship of microstructure formation versus process temperature and load pressure. The depth of indentation was controlled and the load force at a certain indentation depth was measured. Experiments were carried out using 1 mm thick PMMA films with the process temperature ranging from Tg-55 degrees C to Tg +20 degrees C. The embossed structures included a single micro cavity and groups of micro cavity arrays. It was found that at temperature of Tg-55 degrees C, elastic deformation dominated the formation of microstructures and significant relaxation happened after embossing. From Tg-20 degrees C to Tg, plastic deformation dominated polymer deformation, and permanent cavities could be formed on PMMA substrates without obvious relaxation. However, the formation of protrusive structures as micro pillars was not complete since there was little polymer flow. With an increase in process temperature, microstructure could be formed under lower loading pressure. Considering the fidelity of a single microstructure and global flatness of embossed substrates, micro hot embossing at a low process temperature, but with good fidelity, should be preferred.

Experimental Study on Hot Embossing of Micro/Nano Grating

Experimental Study on the Hot Embossing Polymer Microfluidic Chip

Hot Embossing for Nano-grating

Optimization of Control Parameters in Micro Hot Embossing

Experimental Study on the Fabrication of the Light Guide Plate with Hot Embossing Method

Flow Behavior of Polymer During Micro Hot Embossing

Research on Optimization of the Hot Embossing Process

OPTIMUM DESIGN OF PROCESSING CONDITION AND EXPERIMENTAL INVESTIGATION OF GRATING FABRICATION WITH HOT EMBOSSING LITHOGRAPHY

Effect of process parameters on filling behavior of PMMA in hot embossing

Studies of Polymer Deformation and Recovery in Hot Embossing

Defects in Micro Hot Embossing Process

Impact of process parameters on the flow behavior and filling accuracy of photoresist in hot embossing for microgroove array

Investigation of hot roller embossing for microfluidic devices

A parameter study on the micro hot-embossing process of glassy polymer for pattern replication

A New Moiré Grating Fabrication Technique Using Hot Embossing Lithography

Study of Hot Embossing Using Nickel and Ni–PTFE LIGA Mold Inserts

Research on Heat Transfer for Hot Embossing of Polymeric Microfluidic Chips

Micro Structure Fabrication with a Simplified Hot Embossing Method

Simulation Research on Stress of Polymeric Patterns During Micro Hot Embossing

Study on Polymer Flow Profile in Micro Hot Embossing

Using Silicon Molds for Ultrasonic Embossing on Polymethyl Methacrylate (PMMA) Substrates