Characteristics and Reactivity of Rapidly Hydrated Sorbent for Semidry Flue Gas Desulfurization

Jie Zhang,Changfu You,Suwei Zhao,Changhe Chen,Haiying Qi

DOI: https://doi.org/10.1021/es702208e

IF: 11.4

2008-01-01

Environmental Science & Technology

Abstract:Semidry flue gas desulfurization with a rapidly hydrated sorbent was studied in a pilot-scale circulating fluidized bed (CFB) experimental facility. The desulfurization efficiency was measured forvarious operating parameters, including the sorbent recirculation rate and the water spray method. The experimental results show that the desulfurization efficiencies of the rapidly hydrated sorbent were 1.5-3.0 times higher than a commonly used industrial sorbent for calcium to sulfur molar ratios from 1.2 to 3.0, mainly due to the higher specific surface area and pore volume. The Ca(OH)(2) content in the cyclone separator ash was about 2.9% for the rapidly hydrated sorbent and was about 0.1% for the commonly used industrial sorbent, due to the different adhesion between the fine Ca(OH)(2) particles and the fly ash particles, and the low cyclone separation efficiency for the fine Ca(OH)(2) particles that fell off the sorbent particles. Therefore the actual recirculation rates of the active sorbent with Ca(OH)(2) particles were higher for the rapidly hydrated sorbent, which also contributed to the higher desulfurization efficiency, The high fly ash content in the rapidly hydrated sorbent resulted in good operating stability. The desulfurization efficiency with upstream water spray was 10-15% higher than that with downstream water spray.