Abstract:Hybrid silica monoliths functionalized with octyl groups and dedicated to chromatographic separations in the reversed-phase mode were directly synthesized within capillaries according to the protocol described by Yan et al. [L.J. Yan, Q.H. Zhang, Y.Q. Feng, W.B. Zhang, T. Li, L.H. Zhang, Y.K. Zhang, J. Chromatogr. A 1121 (2006) 92]. Although these monoliths allowed reaching high efficiencies in capillary electrochromatography (CEC), serious limitations prohibited their application in nano-liquid chromatography (nano-LC). Such limitations observed as poor performances in the nano-LC mode and the lack of reproducibility of the synthesis were related to the longitudinal morphological inhomogeneities of the hybrid material along the capillary. Thus, several modifications were conducted in the synthesis protocol in order to improve the resulting morphology of the monolith making it suitable for nano-LC separations. The influence of several critical parameters (such as the addition temperature of the basic catalyst and the hydrolysis duration) on the textural and chromatographic properties had been extensively studied. It was found that a decrease (i.e. 0 degrees C) of the temperature addition of the basic catalyst associated with a shorter hydrolysis duration (1h instead of 6h) allowed (i) delaying the gelation time and consequently facilitating the capillary filling step, (ii) increasing the structural homogeneity of the hybrid monoliths, i.e. their chromatographic performances in nano-liquid chromatography also (iii) greatly improving the reproducibility of the synthesis within the capillary without impairing the material's carbon load, i.e. the incorporation of the less hydrolysable C(8) precursor. The resulting hybrid monoliths afforded retention factors comparable to that previously obtained for C(18) grafted silica monoliths and efficiencies that are the best ever recorded in nano-LC with hybrid monoliths and that are close to the ones achieved with grafted silica monoliths. In fact, this modified protocol allowed a significant improvement of the performances in nano-LC which could be observed by the decrease of the mean value of H(min) going from 123 microm (Yan's protocol) to 24 microm (modified protocol) for a same length of capillary (l = 8.5 cm). In addition, the reproducibility of the synthesis was greatly improved through a factor six of reduction on the calculated standard deviation of these efficiencies. The high permeability and longitudinal homogeneity of the synthesized monolith allowed increasing the capillary length (for example, a 75-cm capillary was conveniently filled with hybrid silica monolith) and the column could be eluted at a very low backpressure leading to chromatographic performances up to 40,000 plates. Finally, the good efficiencies in the nano-LC mode combined with the excellent performances already present in the CEC mode led to fast (less than 1 min) and high efficient separations in the pressurized capillary electrochromatography (p-CEC) mode.

Single step on-column frit making for capillary high-performance liquid chromatography using sol-gel technology.

Multi-particle Frits for Packed Capillary Columns in Electrochromatographic Use

Preparation of On-column Frit for Packed Capillary HPLC Column by In-situ Thermo-polymerized Porous Polymer

Application of an In-Situ Thermo-polymerized Porous Polymer: Creation of an On-column Frit for a Packed Capillary HPLC Column

Use of Gel-Casting to Prepare HPLC Monolithic Silica Columns with Uniform Mesopores and Tunable Macrochannels

Preparation and Characterization of Sol-Gel SE-30-Coated Silica Stationary Phase for Capillary Liquid Chromatography

A Graphitized-Carbon Monolithic Column

Preparation and Performance of Inorganic Silica Gel-organic Polymer Mixture Based C_(16) Capillary Monolithic Column

Design, Fabrication, and Evaluation of Microfabricated Columns for Gas Chromatography

Preparation and characterization of inorganic silica-organic polymer mixture based C16 capillary monolithic column

Preparation and Application of Chiral Monolithic Column for Capillary Liquid Chromatography

Fast liquid chromatography method for separation of peptides using a sub‐2 μm ground silica monolith packed column

In-situ solvothermal growth of MOF nanocrystals on the fused silica capillary aiming to prepare new gas chromatography column

Preparation, performance and special applications of glass capillary columns

Optimization of the single-step synthesis of hybrid C(8) silica monoliths dedicated to nano-liquid chromatography and capillary electrochromatography

Preparation of perfusive chromatographic materials via shear-induced reactive gelation

Design and fabrication of fluorous monoliths with tunable surface property for capillary liquid chromatography

Forming Homogeneous Three-Dimensional Structures from Discrete Silica Microspheres Using Sub/Supercritical Water

Development of a gel monolithic column polydimethylsiloxane microfluidic device for rapid electrophoresis separation.

Application of a high-pressure electro-osmotic pump using nanometer silica in capillary liquid chromatography.

Capillary electrochromatography with monolithic silica column: I. Preparation of silica monoliths having surface-bound octadecyl moieties and their chromatographic characterization and applications to the separation of neutral and charged species