Abstract:Due to the high steam velocity and low thermal parameters at the turbine's final stage, steam generates non-equilibrium condensation and forms a large number of small droplets during the process of pressure expansion. The wet steam mixed with droplets impinges on the turbine blades, endangering turbine operation safety and reducing turbine work efficiency. This article modifies the non-equilibrium condensation control equation and embeds it into the numerical simulation software to make the numerical calculation results more accurate. By modifying the inlet steam superheat in the classical experiments, the condensation characteristics of wet steam in Moses–Stein nozzles and Dykas cascades are studied. The results show that increasing inlet superheat can effectively suppress the generation of non-equilibrium condensation and reduce outlet liquid mass fraction. The minimum supercooling temperature of non-equilibrium condensation is only related to the working fluid characteristics (the steam model used in this article is around 20 K). When the inlet superheat of the cascade is large, the rapid condensation region is mainly near the suction surface. In contrast, when the superheat is low, the rapid condensation zone is mainly near the pressure surface. The condensation location is mainly affected by the intensity of internal condensation shock waves in the cascade. Increasing inlet superheat not only increases the shock wave intensity but also decreases the shock wave angle in the passage. When the inlet temperature increases by 20 K, the heat efficiency of the cascade increases by about 1%.

Numerical Study on Homogeneous and Heterogeneous Condensation Flow in Stator of Steam Turbine

Numerical Investigation on Wet Steam Non-Equilibrium Condensation Flow in Turbine Cascade

Numerical Simulation Of Wet Steam Condensing Flow Based On A Two-Fluid Model

Performance of non-equilibrium condensation flow in wet steam zone of steam turbine based on modified model

A Three-dimensional Numerical Simulation of Wet Steam Condensation Flows Based on a Dual Fluid Model

Homogeneous/heterogeneous Condensing Flow Modeling in Turbine Cascades

Study of Steady and Unsteady Wet Steam Condensing Flows in a Turbine Stage

Investigation of heterogeneous condensation flow characteristics in the steam turbine based on homogeneous-heterogeneous condensation coupling model using OpenFOAM

Numerical Simulation of 3D Wet Steam Flow with Spontaneous Condensation

NUMERICAL SIMULATION OF SPONTANEOUSLY CONDENSING FLOWS IN A PLANE TURBINE CASCADE

Influence of moisture removal slot on wet steam non-equilibrium condensation flow in turbine cascade

SST k-ω-kp Two-Phase Turbulence Model and Its Application in Numerical Simulation of Wet Steam Flow with Condensation

Status and Progress in Numerical Researches on Wet Steam Two-Phase Condensing Flows in Steam Turbines

The effect of the inlet steam superheat degree on the non-equilibrium condensation in steam turbine cascade

Study of Wet Steam Two-Phase Flow with Condensation in Steam Turbine

Numerical methods development for non-equilibrium wet steam condensing flow

Numerical Study of the Secondary Flow in Steam Turbine Static Cascade under Varying Conditions

Study On Effects Of Spontaneous Condensation On Performance Of Low Pressure Stages In A Steam Turbine

THREE-DIMENSIONAL SIMULATION OF THE CONDENSING FLOW IN THE WET STEAM STAGES OF A STEAM TURBIN

An Upwind Eulerian-Eulerian Model For Non-Equilibrium Condensation In Steam Turbines

Numerical Modeling and High-Order Scheme for Wet Steam Flow