Abstract:As the condensation phenomenon occurs in the low-pressure stages of steam turbines, an accurate modelling of the condensing flows is very crucial and has a significant impact on the development of highly efficient steam turbines. In order to accurately simulate condensing steam flows, it is essential to choose the right condensation model. Further research to enhance condensation models is of special importance because the outcomes of numerical studies of condensation models in recent years have not been entirely compatible with the experiments and there are still uncertainties in this area. Therefore, the main aim of this paper is to evaluate a proposed droplet growth model for modelling condensation phenomenon in condensing steam flows. The new model is derived to profit from the advantages of models based on the continuum approach for large droplets and those based on the kinetic theorem for small droplets, which results in the model being robust for a wide range of Knudsen numbers. The model is implemented into a commercial CFD tool, ANSYS Fluent 2022 R1, using UDFs. The results of the CFD simulations are validated against experimental data for linear cascades within the rotor and stator blade geometries of low-pressure steam turbine stages. The findings clearly demonstrate the superiority of the new model in capturing droplet growth, particularly for very small droplets immediately following nucleation. In contrast, widely used alternative droplet growth models tend to either underpredict or overpredict the droplet growth rate. This research significantly contributes to the ongoing efforts to enhance condensation modeling, providing a more accurate tool for optimizing the design and operation of low-pressure steam turbines, ultimately leading to a higher energy efficiency and a reduced environmental impact.

Non-equilibrium Condensing Flow Modeling in Nozzle and Turbine Cascade

Numerical methods development for non-equilibrium wet steam condensing flow

An Upwind Eulerian-Eulerian Model For Non-Equilibrium Condensation In Steam Turbines

Homogeneous/heterogeneous Condensing Flow Modeling in Turbine Cascades

Flow Computations of Multi-Stages by URANS and Flux Balanced Mixing Models

Numerical Modeling and High-Order Scheme for Wet Steam Flow

A Three-Dimensional Finite Volume Method for Conservation Laws in Conjunction with Modified Solution for Nonlinear Coupled Constitutive Relations

Numerical Investigation on Local Non-equilibrium Flows Using a Diatomic Nonlinear Constitutive Model

Numerical Analysis of the Micro-Couette Flow Using a Non-Newton–fourier Model with Enhanced Wall Boundary Conditions

A New Coupled Computational Method in Conjunction with Three-Dimensional Finite Volume Schemes for Nonlinear Coupled Constitutive Relations

Analytical Method of Nonlinear Coupled Constitutive Relations for Rarefied Non-Equilibrium Flows

Computation of Hypersonic Flows over Flying Configurations Using a Nonlinear Constitutive Model

Performance of non-equilibrium condensation flow in wet steam zone of steam turbine based on modified model

Non-Condensation Turbulence Models with Different Near-Wall Treatments and Solvers Comparative Research for Three-Dimensional Steam Ejectors

Evaluation of a New Droplet Growth Model for Small Droplets in Condensing Steam Flows

A Practical Numerical Simulation Approach for 3D Wet Steam Flow

A NUMERICAL METHOD FOR SPONTANEOUS CONDENSING FLOW AND ITS APPLICATION ON LAVAL NOZZLE

Modeling Droplet Vaporization and Combustion with the Volume of Fluid Method at a Small Reynolds Number

Investigation of heterogeneous condensation flow characteristics in the steam turbine based on homogeneous-heterogeneous condensation coupling model using OpenFOAM

Numerical Simulation of 3D Flow in a Turbine Cascade at Large Incidence

Shock waves characteristics and losses estimation of non-equilibrium condensation flow in nozzle and steam turbine cascade