Abstract:Palladium has long been explored for use in gas sensors because of its excellent catalytic properties and its unique property of forming hydrides in the presence of H2. However, pure Pd-based sensors usually suffer from low response and a relatively high limit of detection. Palladium nanosheets (PdNS) are of particular interest for gas sensing applications due to their high surface area and excellent electrical conductivity. Here, we demonstrate the design and fabrication of low-cost PdNS-based dual gas sensors for room-temperature detection of H2 and CO over a wide concentration range. We fabricated sensors using multiwalled carbon nanotube@PdNS (MWCNT@PdNS) composites and compared their performance against pure PdNS devices for hydrogen sensing based on electrical resistive response. Devices using PdNS alone had a response and response time of 0.4% and 50 s, respectively, to 1% H2 in air. MWCNT@PdNS (1:5 mass ratio) showed enhanced performance at a lower hydrogen concentration with a limit of detection (LODH2) of 5 ppm. Nearly an order of magnitude increase in response was observed on increasing the amount of MWCNT to 50 mass % in the nanocomposite, but the response fell off at low H2 concentration. Overall, these PdNS-based sensors were found to show good repeatability, stability, and performance under humid conditions. Their response was selective for H2versus CH4, CO2, and NH3; the response to CO was comparable in magnitude but opposite in sign to the response to H2. Upon simultaneous exposure to equal concentrations (10 ppm each) of H2 and CO, the response to CO was dominant. The PdNS showed high sensitivity to CO, detecting as little as 1 ppm CO in air at room temperature. The sensitivity to CO could be used either in a stand-alone room-temperature CO detector, where H2 is known not to be present, or in combination with CO and combustible gas detectors to distinguish H2 from other combustible gases.

Palladium Modified Multi-Walled Carbon Nanotubes For Benzene Detection At Room Temperature

Study on Gas Sensing Property of Metal Particle Doped Multi-Walled Carbon Nanotubes

The Research and Application of Polyaniline/Multi-Walled Carbon Nanotubes Composite Sensitive Membrane for Ammonia Gas Detection

A multi-walled carbon nanotube/palladium nanocomposite prepared by a facile method for the detection of methane at room temperature

Benzene Sensors Based on Multi-Walled Carbon Nanotube Networks Decorated with Metal Nanoclusters.

Nanocomposites of Carbon Nanotube (cnts)/cuo with High Sensitivity to Organic Volatiles at Room Temperature

Preparation of CNTs/PANi core/shell-structured nanowires and improvement of sensitivity of chemical sensors

In Situ Prepared Composite of Polypyrrole and Multi-Walled Carbon Nanotubes Grafted with Sodium Polystyrenesulfonate As Ammonia Gas Sensor with Wide Detection Range

Palladium Nanosheet-Based Dual Gas Sensors for Sensitive Room-Temperature Hydrogen and Carbon Monoxide Detection

Nanoporous Functionalized WS2/MWCNTs Nanocomposite for Trimethylamine Detection Based on Quartz Crystal Microbalance Gas Sensor

Highly Sensitive Hydrogen Sensor Based on a New Suspended Structure of Cross-Stacked Multiwall Carbon Nanotube Sheet

Gas sensitivity of a composite of multi-walled carbon nanotubes and polypyrrole prepared by vapor phase polymerization

A composite of polyelectrolyte-grafted multi-walled carbon nanotubes and in situ polymerized polyaniline for the detection of low concentration triethylamine vapor.

Cu(II) Doped Multi-Walled Carbon Nanotubes As Sensing Materials for Toluene Detection

The Research of Sensors for Toluene Detection Based on Multi-Wall Carbon Nanotubes

Multi-Walled Carbon Nanotube-Based Gas Sensor for NH3 Detection at Room Temperature

N-Type Gas Sensing Characteristics of Chemically Modified Multi-Walled Carbon Nanotubes and PMMA Composite

Gas sensing characteristics of multi-wall carbon nanotubes

NiWO 4 Microflowers on Multi-Walled Carbon Nanotubes for High-Performance NH 3 Detection

The distinguished hydrogen sensibility by selecting diameters of single-walled carbon nanotubes and adding sensitive materials

Multi-walled Carbon Nanotube-Based Gas Sensors for NH3 Detection