Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers
Wang Yongming,Zhu Shiqiang,Yang Wei,Li Jie,Zhang Wenzhong,Yuan Nan,Kang Hongze,Fu Maoyin,Liu Yansong,Zhao Liang
DOI: https://doi.org/10.13330/j.issn.1000-3940.2017.09.013
2017-01-01
Abstract:For one typical thin-walled aluminum alloy cover with complex surface, the influences of the punch initial reverse bugling po-sition and the die cavity pressure on wrinkle were analyzed by numerical simulation and experiment method, and the process parameters were optimized. The results indicate that if the punch initial reverse bugling position is below the die surface, there is no pressure in the die cavity with the punch entering the die, and the unsupported blanks are subjected to tensile stress along one direction and compressive stress along another direction and easy to wrinkle. If the punch initial reverse bugling position is above the die surface, the unsupported blanks have been acted by the pressure in the die cavity with the punch entering the die and subjected to bidirectional tensile stress. Thus, the wrinkle can be controlled. If the die cavity is over high, the unsupported blanks will suffer higher tensile stress, and crack is easy to occur. The unsupported blank wrinkle and crack can be eliminated by a reasonable control on the punch initial reverse bugling po-sition and the die cavity pressure.