Abstract:The zero-sequence loop inherently exists in the structure of the three-phase open-end winding permanent-magnet synchronous machine (OW-PMSM) system with common dc bus, which provides the circulating path for zero-sequence current (ZSC) and consequently causes the torque ripple and extra system loss. Besides, the common-mode voltage (CMV), which can cause many negative effects, such as the bearing current and the failure of motor bearing, is another concern in the driving system. However, the simultaneous suppression of ZSC and the CMV control of the devices is investigated mainly in the application of the induction machine system and the multiphase OW-PMSM system, whereas it is ignored in the application of the three-phase OW-PMSM system, in which the suppression of ZSC is more complex considering the effect of flux linkage harmonic components. On this basis, this article proposes a strategy that can not only suppress the ZSC, but also eliminate the ripple of CMV in the three-phase OW-PMSM system. In the proposed method, the suppression of ZSC is achieved by synchronously adjusting the duration time of each phase within every control cycle based on the reference voltage of zero-sequence control loop, which can simplify the conventional rearrangement-based scheme. Furthermore, the duration time of each phase is distributed into each switch device of the two inverters, with the principle of eliminating the ripple of CMV. Consequently, both the suppression of ZSC and the CMV control can be achieved easily. Furthermore, the influence of dead time on the CMV control is analyzed, indicating that the CMV control is irrelevant with the dead time. Moreover, the effective modulation range of the proposed technique is analyzed. Finally, the experimental validation is conducted on a three-phase OW-PMSM system with common dc bus.

Zero-sequence Current in Direct Drive Variable-speed Constant-frequency Wind Energy Conversion Systems

Modeling And Control Of Zero-Sequence Current In Multiple Grid Connected Converter

Zero-Sequence Current Suppression Strategy of Open-Winding PMSG System With Common DC Bus Based on Zero Vector Redistribution

Zero Sequence Current Suppression Strategy for Open Winding PMSG Fed by Semi-controlled Converter

Current Zero-Crossing Duration Reduction of a Semicontrolled Open-Winding PMSG System Based on Third Harmonic Current Injection

A Family of Novel Zero-Voltage Switching Three-Phase PWM Converters Topology for Distributed Generation

Investigation and Suppression of Current Zero Crossing Phenomenon for a Semicontrolled Open-Winding PMSG System

Parallel Operation of Full Power Converters in Permanent-Magnet Direct-Drive Wind Power Generation System

Unit Power Factor Control of Direct-Drive Permanent Magnet Wind Generator

Zero Sequence Current Suppression Strategy for Open Winding Permanent Magnet Synchronous Motor with Common DC Bus

Dual Stator Windings PMSG Fed by Half-Controlled Converters for Wind Power Application

Control Strategy for Open Winding PMSM System Supplied by the Z-source and Voltage Source Integrated Converters

Parallel Strategy of Direct-driven Variable-speed Constant-frequency Wind Turbine System with Separate DC Buses

Application of Modular Multilevel Converter in Medium Voltage High Power Permanent Magnet Synchronous Generator Wind Energy Conversion Systems

Zero Sequence Circulating Current Reduction of Paralleled Converters with Interleaved Discontinuous PWM

Circuit-level Parallel Strategies of Three Phase PWM Converters Without Zero Sequence Circulating Current

Zero-Sequence Current Suppression Strategy with Common-Mode Voltage Control for Open-End Winding PMSM Drives with Common DC Bus

An Optimized Control Strategy to Improve the Current Zero-Crossing Distortion in Bidirectional AC/DC Converter Based on V2G Concept

Zero-Sequence Current Suppression Strategy with Reduced Switching Frequency for Open-End Winding PMSM Drives with Common DC BUS

An efficient experimental method for high power direct drive wind energy conversion systems

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.