Abstract:Spiral welded tubes (SWTs) are formed by rolling steel plates at a certain angle and welding the resulting abutting edges. They are extensively utilized because of their large diameter ranges, high production efficiency, and low production cost. Thin-walled spiral welded tubes with large diameter-to-thickness ratios are susceptible to local buckling under compressive load, and their performance can be affected by corrosive environments. Therefore, this paper proposed the use of carbon fiber-reinforced polymer (CFRP) to strengthen tubes by external bonding. There are limited studies on the axial compression behavior of CFRP strengthened spiral welded tubes, particularly studies that consider the initial imperfections and residual stresses in spiral welded tubes. To bridge this gap, this paper first investigated the distributions of initial imperfections and residual stresses in spiral welded tubes, finding that both are significantly influenced by distinct forming and welding manufacturing processes. Subsequently, axial compression tests were carried out on four unstrengthened specimens and twelve CFRP-reinforced specimens to investigate the compressive behavior by considering the diameter-to-thickness ratio, the length of the steel tubes, and CFRP layer orientation. The experimental results indicate that CFRP strengthening delays local buckling, and significantly enhances the yield load, ultimate load, and initial stiffness of spiral welded tubes, achieving a maximum increase of the yield load up to 69.11% and the ultimate load up to 61.99%, while its impact on the ductility index remains uncertain and is influenced by variables such as the diameter-to-thickness ratio of the tubes and the CFRP layer orientation. Finally, a comparison of the ultimate loads of the specimens by tests and design codes was conducted.

Experimental and numerical study of mechanical properties of filament-wound CFRP tubes

Modelling of Concrete-Filled Filament-Wound FRP Confining Tubes Considering Nonlinear Biaxial Tube Behavior

Investigation on Mechanical Behavior of Filament-Wound Cfrp Tubes

Experimental Study of Mechanical Properties of CFRP under Different Strain Rates and Temperatures

Characteristic Investigation on Strength of Filament-Wound CFRP Tubes

Quasi-static Axial Crushing and Transverse Bending of Double Hat Shaped CFRP Tubes

Experimental and Numerical Study on CFRP Tubes under Axial Crushing

CHARACTERISTIC ANALYSIS AND EXPERIMENTAL INVESTIGATION ON STRENGTH OF FILAMENT-WOUND CFRP TUBES

EXPERIMENTAL STUDY ON CENTRIFUGAL CONCRETE-FILLED STEEL TUBES UNDER BENDING AND TORSION

FEA AND EXPERIMENTAL STUDY ON RELATION BETWEEN RADIAL DEFORMATION AND TYPICAL FAILURE MODES OF FILAMENT WOUND THICK-WALLED TUBES UNDER AXIAL COMPRESSION

Experimental Research on the Multiaxial Fatigue Behavior of Fibre Reinforced Composites

Behavior and Modeling of Ultra-High Performance Concrete-Filled FRP Tubes under Cyclic Axial Compression

Experimental Investigation of Effect of Winding Angles on Axially Compressive Properties of Thick-Walled C_f/Epoxy Tubes

Experimental and numerical simulation on axial compression of GFRP-long-tube under quasi-static and dynamic loads

Experimental Investigation and Damage Simulation of Large-Scaled Filament Wound Composite Pipes

Experimental Study on Axial Compressive Behavior of Concrete-Filled FRP Filament-winded Tubes

Behavior of CFRP-strengthened Short Spiral Welded Tubes under Axial Load

Micromechanical modeling for longitudinal tensile property of unidirectional CFRP considering dispersion of fiber properties

Investigation on Failure Behavior of Carbon Fiber Reinforced Polymer Wire Subjected to Combined Tension and Bending

Micro-XCT Characterization and Numerical Analysis of Bending Damage Mechanism in Carbon Fiber Plain, Twill and Winding Composite Tubes

Experimental Research on Concrete-Filled GFRP Tubes and GFRP-Steel Composite Tubes under Axial Compressive Load