Abstract:Lightning impulse has the biggest influence on the insulation structure of power transformer, which may lead to transformer breakdown. When the transformer is subjected to lightning impulse, the complex electromagnetic process will be produce on the winding. The overvoltage distribution along the winding is a very important issue for the designers of insulation structure. In this paper, a 35kV cast resin dry-type transformer is taken as an example to establish the FEM simulation model. The inductance and capacitance distribution parameters of the high voltage winding are analyzed and calculated. Then, according to the actual structure of the transformer, each section of coil is divided into one unit for the equivalent circuit of transformer. The transient overvoltage distribution of each section under the action of lightning voltage is analyzed by using the Simulink simulation toolbox of MATLAB. For more detailed research, each section is remodeled as a sub model that each turn conductor is divided into a unit. The ground voltage of each turn and turn to turn voltage under lightning impulse are calculated. The results show that due to the existence of the distributed inductance and capacitance, there is a hysteresis and oscillation in the potential of each section. The maximum potential exceeds the peak of the lightning impulse voltage, and appears at Section 3, 4, 5, which near the low voltage windings. At about 10µs, potential of Section 3, 4, 5 rises to the maximum, and electric field is concentrated in the air channel between the high and low windings, which is about 3.5 kV/mm. The front and the end sections have maximum voltage between sections and maximum electric field between turns.

Modeling of Transformer Winding for Very Fast Transient Voltage Simulation Based on Quasi-Stationary Electromagnetic Field

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Piecewise Frequency-domain Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage Simulations

The Numerical Simulation Method of Transformer Internal Short-Circuit Fault

Calculation of Very Fast Transient Overvoltage Distributions in Large Power Transformer Windings

Improved lumped parameter model for transformer fast transient simulations

Wide Band Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage (VFTO) Analysis

Calculation of Fast Transient Voltage Distributions in Transformer Windings Using Generalized Eigenvalue Method

A Modified Lumped Parameter Model of Distribution Transformer Winding

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Inter-Turn Breakdown Fault Analysis and Winding Structure Optimisation of Winding of Dry-Type Transformers in Wind Farms

FE-based equivalent circuits for simulating transformer internal faults

High-Frequency Modeling and Simulation of a Single-Phase Three-Winding Transformer Including Taps in Regulating Winding

Voltage Transformer Winding Impulse Over-Voltage Study

Modeling and Simulation of Transformer Inter-Turn Short-Circuit Faults Based on Field-Circuit Coupling

Wide-band Modeling of HVDC Converter Transformer for EMTP and Its Application on Fault Analysis

Modeling And Simulation Of Magnetizing Inrush Current Of Large Power Transformers

Component-Level Thermo-Electromagnetic Nonlinear Transient Finite Element Modeling of Solid-State Transformer for DC Grid Studies

Analysis of lightening impulse response of cast resin dry-type transformer