Abstract:The combination of oxy-fuel and porous media combustion can considerably broaden the lean-burn limit while significantly improving combustion stability. It is foreseeable that some of the deficiencies under oxyfuel condition will be overcome. In this paper, a two-layer porous burner model is established, in which the CH 4 skeletal kinetic mechanism and a two-temperature equation model are adopted for calculation purposes. Corresponding experiments are set up to verify the accuracy of the mathematical model. After that, the stable range and temperature field under oxy-fuel conditions, as well as the resulting CO emissions, are studied in detail. The stable range can be substantially broadened by adjusting the equivalence ratio and the oxygen fraction in the combustion-supporting gas. Stable combustion can be achieved under an inlet velocity of 2–29 cm/s and a thermal load of 36–834 kW/m 2 . Properly preheating the premixed gas can also effectively broaden the stable range, while the flame temperature will not rise sharply. The difference in the peak temperature between the solid and gas phases is in the range of 170–200 K. In addition, the peak temperature of the solid phase is located 0.8–1.2 cm downstream that of the gas phase. Extremely low or high equivalence ratios and oxidizer ratios need to be avoided, as they can introduce large amounts of CO emissions. When the flame peak temperature is controlled between 1300 and 1700 K, the CO emissions can reach values lower than 5 ppm.

Simulation of Partial Oxidation of Methane to Acetylene with Detailed Reaction Mechanism

Simulations of Methane Partial Oxidation by CFD Coupled with Detailed Chemistry at Industrial Operating Conditions

A Study of Acetylene Production by Methane Flaming in a Partial Oxidation Reactor

Simulation of Partial Oxidation of Natural Gas with Detailed Chemistry: Influence of Addition of H2, C2H6 and C3H8

Experimental Study on Non-catalytic Partial Oxidation of Methane to Acetylene and Syngas

Experimental study and kinetics modeling of partial oxidation reactions in heavily sooting laminar premixed methane flames

Homogeneous partial oxidation of methane to methanol-a simulation by CHEMKIN-III

Detailed Chemistry Modeling of Partial Combustion of Natural Gas for Coproducing Acetylene and Syngas

Simulation of Carbon Deposition Conditions in a Methane or Acetylene Flame Based on Mechanisms of Chemical Transport Reaction

Detailed kinetic modeling of catalytic oxidative coupling of methane

Simulation and Analysis of Fixed-Bed Reactor for Hydrochlorination of Acetylene

Reduced Mechanism for the Oxidation of Ethene

Enhancing the Acetylene Yield from Methane by Decoupling Oxidation and Pyrolysis Reactions: A Comparison with the Partial Oxidation Process

Insight into the high-temperature oxidation kinetics of acetylene: A first-principles molecular dynamics study

Modeling of Non-Catalytic Partial Oxidation of Natural Gas under Conditions Found in Industrial Reformers

Kinetics Modeling of Non-catalytic Partial Oxidation of Natural Gas

Multiscale Modeling and Simulation on Oxidative Dehydrogenation of Ethane to Ethylene

Effect of Ethane and Propane Addition on Acetylene Production in the Partial Oxidation Process of Methane

Simulation of Partial Oxidation of Methane on the Rhodium Coated Foam Monolith Based on the Elementary Kinetics

Numerical Simulation of Methane Combustion in Two-Layer Porous Media Under Oxy-Fuel Condition

Dissection of the Multichannel Reaction of Acetylene with Atomic Oxygen: from the Global Potential Energy Surface to Rate Coefficients and Branching Dynamics.