Preparation, biomimetic apatite induction and osteoblast proliferation test of TiO2-based coatings containing P with a graded structure

Daqing Wei,Yu Zhou
DOI: https://doi.org/10.1016/j.ceramint.2009.01.007
IF: 5.532
2009-01-01
Ceramics International
Abstract:TiO2-based coatings containing P (T–P) were prepared on Ti6Al4V by microarc oxidation (MAO) with applied voltages of 200–400V in an electrolyte containing (NaPO3)6 and NaOH. The surfaces of the T–P coatings became rough and the thickness increased with increasing the applied voltage. Above 200V, anatase was found on the surface, and rutile was observed at 400V. With increasing the coating thickness, the O and P concentrations increase; while Ti and Al concentrations decrease. Ti, O and P elements display a uniform distribution character around the micropores on the surface of the T–P coating formed at 300V. However, the inner of the micropores exhibits a high Ti concentration and low O and P concentrations due to the graded distributions of Ti, O and P elements in the T–P coating. The apatite-forming ability of the T–P coating formed at 300V was evaluated by immersing in a simulated body fluid (SBF) for 28 and 56 days. The results indicate that biomimetic apatite was formed on the surface of the T–P coating after immersion in SBF for 56 days. And the further cell experiment indicates that the T–P coating can provide surface suitable for the MG63 cell proliferation.
What problem does this paper attempt to address?