Abstract:SummaryThe concurrent multiscale method, which couples the discrete element method (DEM) for predicting the local micro‐scale evolution of the soil particle skeleton with the finite element method (FEM) for estimating the remaining macro‐scale continuum deformation, is a versatile tool for modeling the failure process of soil masses. This paper presents the separate edge coupling method, which is degenerated from the generalized bridging domain method and is good at eliminating spurious reflections that are induced by coupling models of different scales, to capture the granular behavior in the domain of interest and to coarsen the mesh to save computational cost in the remaining domain. Cundall non‐viscous damping was used as numerical damping to dissipate the kinetic energy for simulating static failure problems. The proposed coupled DEM–FEM scheme was adopted to model the wave propagation in a 1D steel bar, a soil slope because of the effect of a shallow foundation and a plane‐strain cone penetration test (CPT). The numerical results show that the separate edge coupling method is effective when it is adopted for a problem with Cundall non‐viscous damping; it qualitatively reproduces the failure process of the soil masses and is consistent with the full micro‐scale discrete element model. Stress discontinuity is found in the coupling domain. Copyright © 2017 John Wiley & Sons, Ltd.

Seepage Analysis Based on Boundary-Fitted Coordinate Transformation Method

A 3D Composite Finite Element Used to Model a Vertical Drain and Its Surrounding Remoulded Soil

Analysis of the Behaviors of Foundation Pit with Excavation Considering Variation of Seepage Free Surface

Time Effect of Excavation Considering the Coupling of Seepage Flow and Soil Deformation

A Method for Determining Critical Thickness of Base Soil of Foundation Pit Subjected to Confined Water

Boundary Point Method for Dam Foundation Seepage Analysis

Combination of slices method and FEM for slope stability analysis of foundation pit under the seepage condition

Treatment of Transitional Element with the Monte Carlo Method for FEM-based Seepage Analysis

Analytical Solutions of Steady a Seepage Field for Deep-Buried Tunnel with Grouting Ring Considering Anisotropic Flow

Seepage analysis based on the unified unsaturated soil theory

Free Surface Seepage Analysis Based on the Element-Free Method

Seepage calculation of earth-rockfill dams with vertical cut-off wall on infinite deep pervious foundation by using transformation method

A direct time-domain procedure for the seismic analysis of dam–foundation–reservoir systems using the scaled boundary finite element method

Numerical analysis of dewatering-induced deformation of foundation pit

Analytical Solutions for Seepage Field of Underwater Tunnel

A Three-Dimensional Numerical Method for Siphon Drainage Process Simulation

Analytical solutions for the steady-state seepage field in a finite seabed with a lined tunnel

DEM–FEM Analysis of Soil Failure Process Via the Separate Edge Coupling Method

Numerical Analysis of Seepage for Concrete Face Rockfill Dam with Cracks Based on Block Equivalent Continuum Method

Numerical Simulation of Piping Based on Coupling Seepage and Pipe Flow

Three Dimensional Analysis of Unconfined Seepage in Earth Dams by the Weak Form Quadrature Element Method