Abstract:A novel membrane vacuum regeneration (MVR) technology was developed to achieve lower regeneration energy demand for CO2 absorption process. Sixteen different amine-based absorbents including primary, secondary, tertiary amines, polyamines, diamines, and sterically hindered amines were analyzed by combined absorption–desorption screening experiments for selecting the most effective absorbents for CO2 membrane vacuum regeneration (MVR) technology. The CO2 absorption experiments were conducted in a hollow fiber membrane contactor (HFMC) at 25°C and 12.5kPa CO2 partial pressure. The CO2 rich solvent was regenerated at 75°C and 20kPa regeneration pressure by using the MVR technology. The chain length, number of functional groups, side chain, and number of hydroxyl groups of amines were investigated to get a better understanding on the effects of the structure in the MVR process. The results show that the tertiary amines have greater regeneration performances than the primary amines, but the CO2 absorption rates of the tertiary amines are worse than the primary amines. For the polyamines, the absorption performance of polyamines can be improved by increasing the number of amine groups while the MVR performance of the polyamines can be reduced. Steric hindered amines exhibited greater MVR performances. In addition, amines with steric hindrance effect caused by the substitution of hydroxyl group or methyl group to amine group in structure has also shown good performance in the MVR process for CO2 desorption. The overall performance of amine-based absorbents was also investigated by an absorption–desorption characters analysis. It shows triethylenetetramine (TETA) and N-methyldiethanolamine (MDEA) have great average CO2 absorption rates and relatively high cyclic capacities per mole absorbent, and ethylenediamine (EDA) is considered to be the promising absorbent as cyclic capacity in mol CO2/kg absorbent. Diethanolamine (DEA) and 2-Amino-2-methyl-1-propanol (AMP) are found to have the best overall performances in terms of CO2 absorption rate at lean loading and cyclic capacity in mol CO2/mol absorbent. In terms of overall performance, MDEA is mostly recommended for using in MVR process. Sweeping steam can significantly improve MVR performance in most selected absorbents except AMP and 2-amino-2-hydroxymethyl-1,3- propanediol (THAM) absorbents which present the potential to reduce the regeneration energy demand by operating without sweeping steam. The study also finds that MVR shows better regeneration performance as compared to traditional thermal regeneration process at the same regeneration temperature.

Co(2) Chemical Absorption by Using Membrane Vacuum Regeneration Technology

CO2 Desorption from Rich Alkanolamine Solution by Using Membrane Vacuum Regeneration Technology

Experimental Study on Regeneration Characteristics of CO2-rich Blended Amine Solution Using Membrane Vacuum Regeneration Technology

Membrane Stripping Technology for CO2 Desorption from CO2-rich Absorbents with Low Energy Consumption

Removal of CO2 from Simulated Flue Gas of Power Plants by Membrane-Based Gas Absorption Processes

Regeneration of CO2 from CO2-rich alkanolamines solution by using reduced thickness and vacuum technology: Regeneration feasibility and characteristic of thin-layer solvent

Comparison and Selection of Amine-based Absorbents in Membrane Vacuum Regeneration Process for CO2 Capture with Low Energy Cost

Experimental research on chemical desorption based on CO2-rich absorption solutions

Amine-based absorbents selection for CO2 membrane vacuum regeneration technology by combined absorption–desorption analysis

Mixed Amine Absorbent based on Hollow Fiber Membrane Contactor Removes CO2 from Flue Gas

Experimental Study of CO2 Regeneration from Ammonia Rich Solution by Membrane Vacuum Regeneration

Regeneration Performance of CO2-rich Solvents by Using Membrane Vacuum Regeneration Technology: Relationships Between Absorbent Structure and Regeneration Efficiency

Comparative Analysis of CO2 Separation from Flue Gas by Membrane Gas Absorption Technology and Chemical Absorption Technology in China

CO2 Capture by Using a Membrane-absorption Hybrid Process in the Nature Gas Combined Cycle Power Plants

Separation of CO2 in Flue Gas by Membrane Absorption in China

Study on CO2 Absorption-Mineralization Characteristics of Mixed Amine Solution Coupled with CaO and Key Influencing Factors in Mineralization Process

Study on desorption of CO2-rich solution by membrane

CO2 separation from flue gases by polypropylene hollow fiber membrane contactor

CO2 trapping method combining dimethyl carbonate absorption and membrane desorption

Can CO2 Regeneration Heat Consumption Be Reduced by Using the Novel &#147;mass Concentration of Solvent Swing Regeneration (mcsr)&#148; Technology?

Study on the Mechanism and Energy Consumption of CO2 Regeneration Process by Membrane Electrolysis