Studies On High Density Polyethylene (Hdpe) Functionalized By Ultraviolet Irradiation And Its Application

Ss Wu,J Zhang,X Xu

DOI: https://doi.org/10.1002/pi.1251

IF: 3.213

2003-01-01

Polymer International

Abstract:The structure and properties of high density polyethylene (HDPE) functionalized by ultraviolet irradiation at different light intensities in air were studied by electron analysis, FTIR spectroscopy, contact angle with water, differential scanning calorimetry and mechanical properties measurement. The results show that oxygen-containing groups such as C=O, C-O and C(=O)O were introduced onto the molecular chain of HDPE following irradiation, and the rate and efficiency of HDPE functionalization increased with enhancement of irradiation intensity. After irradiation, the melting temperature, contact angle with water and notched impact strength of HDPE decreased, the degree of crystallinity increased, and their variation amplitude increased with irradiation intensity. Compared with HDPE, the yield strength of HDPE irradiated at lower light intensity (32 W m(-2) and 45 W m(-2)) increases monotonically with irradiation time, and the yield strength of HDPE irradiated at higher light intensity (78 W m(-2)) increases up to 4S h and then decreased with further increase in irradiation time. The irradiated HDPE behaved as a compatibilizer in HDPE/polycarbonate (PC) blends, and the interface bonding between HDPE and PC was ameliorated. After adding 20 wt% HDPE irradiated at 78 W m(-2) irradiation intensity for 24 h to HDPE/PC blends, the tensile yield strength and notched Izod impact strength of the blend were increased from 26.3 MPa and 51 J m(-1) to 30.2 MPa and 158 J m(-1), respectively. (C) 2003 Society of Chemical Industry.