Abstract:M 23 C 6 carbide can precipitate simultaneously on both sides of austenite grain boundary in Fe–15Mn–3Al-0.7C steel tempered at 600 °C. In this paper, the morphology and growth behavior of M 23 C 6 are studied by means of OM, SEM and TEM. The results show that the morphology of M 23 C 6 located on both sides of grain boundary is different. On one side of the grain boundary, the carbides appear to be dispersed and disconnected, each with an irregular particle-like morphology, while on the opposite side, they are dispersed along the grain boundary in a short-rod morphology, and the adjacent ones tend to join together to form a network structure. In fact, regardless of which side of the grain boundary the carbides are on, they exhibit a definite growth behavior, growing along the close-packed plane and grain boundary. Also, the morphology of M 23 C 6 depends on the angle between the close-packed plane and the grain boundary. In addition, twin structures with the same orientation can be found in both austenite and M 23 C 6 . A notable distinction between them is that there is a flat twin plane in the austenite twin structure but not in the carbide twin structure. Therefore, this paper highlights that the formation of these two twin structures is different. The austenite twin structure is caused by quenching treatment, while the carbide twin structure is formed by a new method called "growing-contacting".

Characteristics of the A/D Type Twin Boundary in 18R Martensite in a Cu–Zn–Al Alloy

On the A/D type twin boundary in 18R martensite of a Cu-Zn-Al alloy

The structure and mobility of the intervariant boundaries in 18R martensite in a Cu–Zn–Al alloy

Substructure and Boundary Structure of Deformed 18R Martensite in a Cu–Zn–Al Alloy

Structure And Mobility Of Martensite Variant Interfaces In A Cu-Zn-Al Shape Memory Alloy

High-Resolution Electron-Microscopy Observation of the Fine-Structure of Cu-Zn-Al Martensites

Type II defect in 18R martensite in a Cu-Zn-Al alloy

Intrinsic twin boundary of η-MgZn2 precipitates in the AA7050 aluminium alloy

THE TYPE II DEFECT IN 18R MARTENSITE IN A Cu-Zn-Al ALLOY

Hrem Studies of Twin Boundary Structure in Deformed Martensite in the Cold-Rolled Tini Shape Memory Alloy

Structure characterization of special boundaries in Fe47Mn30Co10Cr10B3 dual-phase high-entropy alloy

Multiple morphologies and twin structure generated by a definite growth behavior of grain boundary M 23 C 6 in tempered Fe–15Mn–3Al-0.7C steel

Orientation dependence of damping behavior in a Mn-Cu shape memory alloy

Ab-Initio Study of Electronic Structure of Martensitic Twin Boundary in Ni2MnGa Alloy

On the Faceted and Inclined Twin Boundary of Titanium Carbide Derived from Nanolaminated Ti3AlC2

Substructure and Interface of the Superstructure Martensite in Zr50Cu50 High Temperature Shape Memory Alloy

A general method for twin element analysis and its application in Cu–Zn–Al shape memory alloys with M18R martensite

Characteristic boundaries associated with three-dimensional twins in hexagonal metals

The Effect of Basal Dislocation on 112¯1 Twin Boundary Evolution in a Mg-Gd-Y-Zr Alloy

Difference in fatigue cracking behaviors of Cu bicrystals with the same component grains but different twin boundaries

General Existence of Ledges on Α1 Plates in Cu-Zn-Al Alloys