Abstract:This paper is focused on a dual-loop current control method (grid current loop and fundamental current loop) for digitally controlled LCL-type shunt active power filters (APFs). Normally, a proportional-resonant (PR) unit is used as the fundamental current controller, where the proportional part of PR unit actually serves as the proportional feedback of inverter-side current and provides a certain degree of damping for LCL resonance. However, its valid damping region is only up to one-sixth of the sampling frequency (fs/6), which leads to less robustness to the grid impedance. To address this issue, a delay-compensation control link is proposed in this paper to replace the proportional part of the PR fundamental current controller and widen the effective damping region. As a result, the system robustness is improved without adding extra sensors or introducing an extra active damping loop. Theoretical analysis proves that it can obtain a wider damping region of (0, fs/4). Moreover, a systematic controller parameter design criterion is studied. In particular, a numerical optimization algorithm is developed to optimize damping property, and a design method based on root locus plot and Bode diagram is presented to enhance harmonic compensation accuracy. Finally, experimental results implemented on a 30 kVA APF prototype have validated the feasibility of the proposed current controller and parameter design criterion.

On Using Linear Periodically resetting Filter in Current Control Loop for Active Power Filter

On Using Resetting Integrator in Current Control Loop for Active Power Filter

A Robust Dual-Loop Current Control Method with a Delay-Compensation Control Link for LCL-Type Shunt Active Power Filters

Research on PI and Repetitive Control Strategy for Shunt Active Power Filter with LCL-filter

A Systematic Approach Via IIR Filters for Enhancing the Robustness of LCL-Type Shunt Active Power Filters to Grid Impedance

Current Control of LCL-Type Shunt APFs: Damping Characteristics, Stability Analysis, and Robust Design Against Grid Impedance Variation

A Current Control Method for LCL Active Power Filters Based on the Reduced Order Generalized Integrator

Robust Current Control Method for LCL-Type Shunt Active Power Filters with Inverter-Side Current Feedback Active Damping

A simple method of realization of low power loss and high compensation-precision active power filter

Current Loop Control Approach for LCL-based Shunt Active Power Filter

Design of the Repetitive Control Method for Active Power Filter

A noise rejection deadbeat control technique for active power filter

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

A waveform control technique for high power Shunt Active Power Filter based on repetitive control algorithm

A Novel Control Approach for LCL-based Shunt Active Power Filter with High Dynamic and Steady-State Performance

An Enhanced Active Damping Control Method for <i>LCL</i>-Type Shunt APFs with Proportional-Resonant-Differential Inverter-Side Current Feedback

Robust Deadbeat Control Scheme for a Hybrid APF with Resetting Filter and ADALINE-Based Harmonic Estimation Algorithm

Comparison of Fixed and Variable Sampling Frequency Digital PLL for Active Power Filters

Virtual Resistor Control Strategy of Parallel Active Power Filter with LCL Filter

Repetitive Control Design and Debugging in Active Power Filter

A Novel Active Damping Method for LCL-filter-based Shunt Active Power Filter