Abstract:This paper is focused on a dual-loop current control method (grid current loop and fundamental current loop) for digitally controlled LCL-type shunt active power filters (APFs). Normally, a proportional-resonant (PR) unit is used as the fundamental current controller, where the proportional part of PR unit actually serves as the proportional feedback of inverter-side current and provides a certain degree of damping for LCL resonance. However, its valid damping region is only up to one-sixth of the sampling frequency (fs/6), which leads to less robustness to the grid impedance. To address this issue, a delay-compensation control link is proposed in this paper to replace the proportional part of the PR fundamental current controller and widen the effective damping region. As a result, the system robustness is improved without adding extra sensors or introducing an extra active damping loop. Theoretical analysis proves that it can obtain a wider damping region of (0, fs/4). Moreover, a systematic controller parameter design criterion is studied. In particular, a numerical optimization algorithm is developed to optimize damping property, and a design method based on root locus plot and Bode diagram is presented to enhance harmonic compensation accuracy. Finally, experimental results implemented on a 30 kVA APF prototype have validated the feasibility of the proposed current controller and parameter design criterion.

Robust Current Control Method for LCL-Type Shunt Active Power Filters with Inverter-Side Current Feedback Active Damping

Current Control of LCL-Type Shunt APFs: Damping Characteristics, Stability Analysis, and Robust Design Against Grid Impedance Variation

A Robust Dual-Loop Current Control Method with a Delay-Compensation Control Link for LCL-Type Shunt Active Power Filters

A Systematic Approach Via IIR Filters for Enhancing the Robustness of LCL-Type Shunt Active Power Filters to Grid Impedance

Robust Active Damping Control for LCL-Type Shunt Active Power Filters

A Current Control Method for LCL Active Power Filters Based on the Reduced Order Generalized Integrator

An Enhanced Active Damping Control Method for <i>LCL</i>-Type Shunt APFs with Proportional-Resonant-Differential Inverter-Side Current Feedback

A Novel Active Damping Method for LCL-filter-based Shunt Active Power Filter

A New Feedback Method for PR Current Control of LCL-Filter-Based Grid-Connected Inverter

Mitigation of Grid-Current Distortion for LCL-Filtered Voltage-Source Inverter With Inverter-Current Feedback Control

Active Damping of LCL Filters with All-Pass Filters Considering Grid Impedance Variations and Parameter Drifts

Current Loop Control Approach for LCL-based Shunt Active Power Filter

Design of Digital Filter-based Highly Robust Active Damping for LCL-filtered Grid-tied Inverters

High-Performance Resonant Controller For Active Power Filter With Selective Harmonic Compensation

A Novel Control Approach for LCL-based Shunt Active Power Filter with High Dynamic and Steady-State Performance

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

A Double-Loop Current Control Strategy for Shunt Active Power Filter with Lcl Filter

Phase Reshaping Via All-Pass Filters for Robust LCL-Filter Active Damping

Active Damping Control for LCL Filters with Inverter-Side Current Feedback Only

Virtual Resistor Control Strategy of Parallel Active Power Filter with LCL Filter

Robust Design of LCL-filters for Active Damping in Grid Converters