Abstract:Mathematical modeling has become an indispensable tool for sustainable wastewater management, especially for the simulation of complex biochemical processes involved in the activated sludge process (ASP), which requires a substantial amount of data related to wastewater and sludge characteristics as well as process kinetics and stoichiometry. In this study, a systematic approach for calibration of the activated sludge model one (ASM1) model for a real municipal wastewater ASP was undertaken in GPS-X. The developed model was successfully validated while meeting the assumption of the model’s constant stoichiometry and kinetic coefficients for any plant influent compositions. The influences of vital ASP parameters on the treatment plant performance and capacity analysis for meeting local discharge limits were also investigated. Lower influent chemical oxygen demand in mgO2/L (COD) could inhibit effective nitrification and denitrification, while beyond 250 mgO2/L, there is a tendency for effluent quality to breach the regulatory limit. The plant performance can be satisfactory for handling even higher influent volumes up to 60,000 m3/d and organic loading when Total Suspended Solids/Volatile Suspended Solids (VSS/TSS) and particulate COD (XCOD)/VSS are maintained above 0.7 and 1, respectively. The wasted activated sludge (WAS) has more impact on the effluent quality compared to recycle activated sludge (RAS) with significant performance improvement when the WAS was increased from 3000 to 9000 m3/d. Hydraulic retention time (HRT) > 6 h and solids retention time (SRT) < 7 days resulted in better plant performance with the SRT having greater impact compared with HRT. The plant performance could be sustained for a quite appreciable range of COD/5-day Biochemical Oxygen Demand (BOD5 in mgO2/L) ratio, Mixed Liquor Suspended Solid (MLSS) of up to 6000 mg/L, and when BOD5/total nitrogen (TN) and COD/TN are comparatively at higher values. This work demonstrated a systematic approach for estimation of the wastewater treatment plant (WWTP) ASP parameters and the high modeling capabilities of ASM1 in GPS-X when respirometry tests data are lacking.

[Modeling and Dynamic Simulation of the Multimode Anaerobic/anoxic/aerobic Wastewater Treatment Process].

Model Reduction Based on Time-Scale Decomposition for Wastewater Treatment Process

The Using of a Mathematical Model Based on ASM3 to Actual Process

Modeling and simulation of an extended ASM2d model for the treatment of wastewater under different COD: N ratio

Modeling the Performance of Anaerobic Digestion Reactor by the Anaerobic Digestion System Model (ADSM)

Modeling and Simulation of a Biological Process for Treating Different COD:N Ratio Wastewater Using an Extended ASM1 Model

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

Modeling of two-phase anaerobic process treating traditional Chinese medicine wastewater with the IWA Anaerobic Digestion Model No. 1.

Mathematical Simulation of Feedforward Control for Nutrient Removal in Anaerobic-Anoxic-oxic Processes.

Mathematical modeling of upflow anaerobic sludge blanket (UASB) reactors: Simultaneous accounting for hydrodynamics and bio-dynamics

Mathematical Modeling of a Domestic Wastewater Treatment System Combining a Septic Tank, an Up Flow Anaerobic Filter, and a Constructed Wetland

Systematic Modeling of Municipal Wastewater Activated Sludge Process and Treatment Plant Capacity Analysis Using GPS-X

Modeling the dynamic performance of full-scale anaerobic primary sludge digester using Anaerobic Digestion Model No. 1 (ADM1)

Simulation of Heterotrophic Storage and Growth Processes in Activated Sludge under Aerobic Conditions

A simulation-based integrated approach to optimize the biological nutrient removal process in a full-scale wastewater treatment plant

Simulation model of dynamic aerobic compost and its application.

Dynamic Modeling the Anaerobic Reactor Startup Process

Optimization of biological nitrogen removal in full-scale municipal WWTPs using activated sludge model simulation

Simulating a Cyclic Activated Sludge System by Employing a Modified ASM3 Model for Wastewater Treatment.

Development of long-term dynamic BioWin® model simulation for ANAMMOX UASB micro-granular process

Modeling and Simulation of the Sequencing Batch Reactor at a Full‐scale Municipal Wastewater Treatment Plant