Abstract:REBCO coated conductors are now being used for building very high-field magnets with large electromagnetic stresses, both expected ones due to transport current × stresses and additional stresses resulting from the large screening currents inherent in wide tapes. Post mortem analyses of several recent test coils operated above 40 T show that significant conductor plastic deformation occurs, even for JBR stresses well below the ~1 GPa yield of the Hastelloy substrate of the conductor. To investigate these deformation mechanisms, conductors were unwound after coil test and carefully examined with respect to their length-wise Ic which revealed many areas of local damage. Regions of interest were examined by metallographic cross-section, Hall microscopy, magneto-optic imaging and scanning electronic microscopy. Important damage frequently occurred to the outer edges of pancakes in the coil ends, which were often plastically deformed over the whole turn circumference, especially when this outer edge was a slit edge. Internal conductor damage was also seen, especially delamination between the buffer and REBCO layers at slit edges. Careful sectioning of the tape at ~10 mm intervals showed that the plastic deformation of the turns was complex and variable around the turn circumference, with tape cross-sections that exhibited continuous shape change in the outer turns. The bending center line of tapes often shifted from the tape center line toward the edge closest to the coil center, indicating asymmetric effects of transport and screening current stresses across the conductor width. A surprising and vital result is that damage was prevalent when the slit edge was also the edge at which transport current flowed. This damage was absent when the transport current flowed at the not-slit edge, implying great sensitivity of the effect of screening current stresses to localized conductor damage.

Deformation Distribution of Multi-Filament Superconducting Tape During Rolling Process

Deformation Behaviors of Multi-Filamentary Superconducting Wire with Elliptical Section During Rolling

Numerical Modelling of Bscco Powder Deformation in the Bi-2223/Ag Tape Rolling Process

Microforming technology for superconducting Ag/BSSCO tapes

Microforming in Macro-Field and Processing of Bi-2223/Ag Superconducting Tape

Performance Degradation of Multi-Layer Spiral Cable During Manufacturing Procedure

Numerical and Experimental Analysis of Deformation Behaviors and Microstructure Evolution in the Thread Rolling Process

The Influence of Electroplastic Rolling on the Mechanical Deformation and Phase Evolution of Bi-2223/Ag Tapes

Shear deformation characteristics under tensile stress during forming of tubular braided fabrics

Research on Effects of Rolling-Drawing Deformation on Performance of Cu-10Ni-1Fe-1Mn Alloy

Numerical Simulation of Drawing Process for Bi Superconducting Single-filament Tape

Insight into deformation allocation in the multi-pass roll forming of a double-walled brazed tube

Mechanical behavior of HTS tape in highly flexible REBCO cable under tensile and torsional loads

Deformation and crack prediction of CORC cable induced by Poisson effect: Theoretical modeling and experimental validation

The Influence of Inscribed Rolling on Critical Current of Bi-2223/Ag Tapes

Analyses of the plastic deformation of coated conductors deconstructed from ultra-high field test coils

Strain Distribution and Critical Current Characteristics of an Individual REBCO Tape and Quasi-Isotropic Superconducting Strand Under Bending Loads by the Layerwise Theory

Strain dependence of critical current and self-field AC loss in Bi-2223/Ag multi-filamentary HTS tapes: a general predictive model

Experimental Investigation on Constitutive Behaviour of Superconducting Powder BSCCO

Experimental study of local micro-forming for Bi-HTS

Deformation Behavior of Stacked REBCO Tapes under Compressive Loads