Abstract:Using cobaloxime boron fluoride (COBF) and AIBN as catalyst and initiator respectively, the catalytic chain transfer bulk polymerization of 2-hydroxyporpyl methacrylate ( HPMA) was carried out at 60 degrees C and the low molecular weight polymer with a terminal double bond was prepared. The evolution of the apparent chain transfer constant (C-S(spp)) of COBF during the polymerization was determined by the Mayo equation and the CLD (chain length distribution) equation respectively. At the beginning of the reaction the chain transfer constant showed values of up to about 2000, but with the increasing of the monomer conversion, the chain transfer constant decreases and keeps at a value of about 600 for sometime and then decreased again. The most likely cause for the catalyst deactivation is the stable cobalt-carbon bond formed at the first period of the reaction and then reached equilibrium point. When the polymerization proceeds up to middle and high conversion, the chain transfer polymerization is further manipulated by diffusions of polymeric propagating chain and catalyst molecules, and the apparent chain transfer constant fell to value of below 300. It has been found also, that the data determined by the CLD equation are usually lower than those by the Mayo equation, especially at high conversion stage. It is because that both original equations are available for the instantaneous produced polymer or the case of very lower conversion stage. However, the GPC measurements give molecular weight distributions of the cumulated products rather than the instantaneous produced polymer. The number-average polymerization degrees for the instantaneous produced polymers were obtained from the GPC data, and used in the Mayo equation method together with the modification of the monomer concentration. It was believed that the apparent chain transfer constants from the modified Mayo equation method are more available for the middle and high conversion cases.

Minimum end time policies for batchwise radical chain polymerization, part V?multicomponent copolymerization with one charge of comonomers

Minimum end time policies for batchwise radical chain polymerization—III

Minimum end time policies for batchwise radical chain polymerization—III: The initiator addition policies

Minimum end time policies for batchwise radical chain polymerization

110Th Anniversary: Model-Guided Preparation of Copolymer Sequence Distributions Through Programmed Semibatch RAFT Mini-Emulsion Styrene/Butyl Acrylate Copolymerization

Minimum end time policies for batchwise radical chain polymerization—II A two-stage process for styrene polymerization

Targeting Copolymer Composition Distribution Via Model-Based Monomer Feeding Policy in Semibatch Raft Mini-Emulsion Copolymerization of Styrene and Butyl Acrylate

Modeling for the Diffusion Limitation of Free Radical Polymerization

Modeling and Experimentation of RAFT Solution Copolymerization of Styrene and Butyl Acrylate, Effect of Chain Transfer Reactions on Polymer Molecular Weight Distribution

Tailoring Uniform Copolymer Composition Distribution Via Policy II RAFT Solution Copolymerization of Styrene and Butyl Acrylate

Design and Control of Copolymer Composition Distribution in Living Radical Polymerization Using Semi‐Batch Feeding Policies: A Model Simulation

Simulation Studies on the Origin of the Limiting Conversion Phenomenon in Hybrid Miniemulsion Polymerization

Control of Gradient Copolymer Composition in Atrp Using Semibatch Feeding Policy

THE EVOLUTION OF THE CHAIN TRANSFER CONSTANT DURING THE CATALYTIC CHAIN TRANSFER POLYMERIZATION OF 2-HYDROXYPROPYL METHACRYLATE

Toward Polymer Product Design. I. Dynamic Optimization of Average Molecular Weights and Polydispersity Index in Batch Free Radical Polymerization

Controllable Preparation of Complex Polymer Chains and Novel Materials

Modeling and Simulation of Semibatch Emulsion Polymerization

Optimal Temperature Policies for Batchwise Thermally‐initiated Bulk Polymerization of Styrene

Experiment and Simulation on Styrene Polymerization with Linear Bifunctional Initiator 2,5-Dimethyl-2,5-di(2-ethylhexoylperoxy)hexane (Dmdehph)

KINETICS OF STYRENE POLYMERIZATION INITIATED BY DIFUNCTIONAL INITIATOR

Active Kinetic Chain Length: Guide for Control in Atom Transfer Radical Polymerization