Abstract:Parallel transmission lines on the same corridor are commonly used in the transmission system.When a cross country fault occurs,the traditional fault phase selector may not correctly identify the fault phases due to the changes of fault characteristics.An algorithm for the calculation of the sequence currents at the fault point is proposed according to Thevenin”s theorem and the sequence currents at the location of the protection relay are obtained with superposition principle.Finally,the formulas on the relation between sequence currents at the fault point are deduced.Based on the double-circuit transmission lines on the same tower without electrical connection at both ends,it is found that the applicability of the positive and negative sequence current phase selector is related to fault types under cross country non-earth fault conditions,while that under cross country earth fault conditions are related to fault types,mutual inductance as well as the ratio of equivalent zero sequence impedance and positive sequence impedance.In contrast,the phase selector based on the phase current difference change can correctly identify fault phases under different cross country fault conditions of parallel transmission lines on the same corridor. Simulation results based on the PSACD platform show that the analytical method for cross country fault is effective,and the analysis result of fault phase selector is correct.

Fault line selection for four-parallel lines on same tower based on circulation currents

A new method for fault line selection of four-parallel transmission lines

New Single-Line Faulted Selecting Method for Four-Parallel Transmission Lines on the Same Tower Based on Loop Flow Component

A new phase-mode transformation method for fault analysis of four-parallel transmission lines

A new method of fault line selection for teed circuits with four-parallel transmission lines on the same tower

A Parameter Adaptive Fault Location with Two-terminal Data for Four-parallel Transmission Lines on the Same Tower

A New Fault Location Scheme Based On Distribution Parameter For Four-Parallel Transmission Lines On Same Tower

A practical fault phase selection scheme for untransposed double-circuit transmission lines on the same tower

Fault Phase Selection Scheme for Quadruple-Circuit Transmission Lines with Asymmetrical Parameter Based on Single-Ended Electrical Quantities

A new method of fault location with two-terminal data for four-parallel transmission lines on the same tower

Fault Line Selection Scheme of Double HVDC Transmission Lines on Same Tower Based on Potential Coefficient Matrix

Phase-mode Transformation of Four-parallel Lines on the Same Tower

Analysis on Fault Phase Selector for Cross Country Fault of Parallel Transmission Lines

Fault Line Selection Component of Transverse Differential Protection Based on Six-sequence Current Component for Multi-circuit Transmission Line on Same Tower

Fault Location for Parallel Transmission Lines on the Same Tower Based on One-Terminal Current

A short-circuit fault calculation scheme for four-parallel transmission lines

Fault location for four-parallel transmission lines on same tower based on ant colony algorithm

A New Method for Open Conductors Fault Calculation of Four-parallel Transmission Lines

Parameter self-adaptive fault location of four-parallel transmission lines on the same tower

Fault line selection of double-circuit HVDC transmission line based on voltage variation

Phase Component Model Based Calculation Method for Inter-Line Fault Occurred in Parallel Circuits on Same Tower with Zero-Sequence Mutual Induction