Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Robust Design of a Sensorless Bass-Enhanced Moving-Coil ANC Actuator

Modeling, Identification, and Adaptive Robust Motion Control of Voice-Coil Motor Driven Stages

Robust Force Tracking Impedance Control of an Ultrasonic Motor-actuated End-effector in a Soft Environment.

A Suite of Robust Controllers for the Manipulation of Microscale Objects

Design and Implementation of Electromagnetic Active Control Actuators

-Synthesis-Based Adaptive Robust Control of Linear Motor Driven Stages With High-Frequency Dynamics: A Case Study

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Robust Proportional-Differential Control Via Eigenstructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems

Output Feedback Dynamical Compensation Via EigenStructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems.

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

All-coefficient Adaptive Control of Active Magnetic Bearing System Based on Characteristic Model

Feedforward Active Noise Global Control Using a Linearly Constrained Beamforming Approach

Position Optimization for Secondary Speaker and Error Sensor of Duct Active Noise Control System

Dual-channel Space Active Noise Control System for Motor Operating Noise

Robust direct acoustic impedance control using two microphones for mixed feedforward-feedback controller

Robust Improved Multiband-Structured Subband Adaptive Filter for Active Noise Control with Impulsive Interference

Stability Guaranteed Active Noise Control: Algorithms and Applications

Electroacoustic Analysis, Design, and Implementation of A Small Balanced Armature Speaker

Active Feedforward Noise Control and Signal Tracking of Headsets: Electroacoustic Analysis and System Implementation

Narrowband active noise control system with online secondary-path modeling

Combined Feedforward–Feedback Active Control of Road Noise Inside a Vehicle Cabin