Abstract:In this study, a continuum damage mechanics (CDM) finite element (FE) model was developed to investigate the effects of surface roughness on rolling contact fatigue (RCF) life of non-conformal contacts. In order to assess the surface roughness of tribo-components, twelve deep groove rolling element bearings from various companies in different sizes were procured and measured using an optical surface profilometer. The roughness average (Ra) and the root mean square of surface roughness (RMS, σ) ranged from a low of 0.03, 0.05 µm to a high of 0.14, 0.20 µm, respectively. The number of peaks and valleys per 400 µm were measured and calculated. The number of peaks ranged from 11 to 31 (>99.5% Confidence Interval). The measured surfaces also revealed that a sinusoidal pattern can be used to accurately represent the surface patterns. The sinusoidal surface pattern was used to determine the elastohydrodynamic lubrication (EHL) pressure distribution between an equivalent rough surface in contact with a smooth surface. Four roughness amplitude were used to generate specific film thicknesses (λ-ratios) resulting in full to mixed EHL lubrication regimes. The EHL pressure distributions were replaced with representative symmetric Hertzian pressure distributions in order to remove the effect of asymmetry of an EHL pressure distribution. The resulting symmetric pressure distributions were used in a finite element continuum damage mechanics model to determine RCF life of machine elements operating in specific film thickness range of 1 < λ < 10. The RCF results from the FE model indicate that as roughness amplitude increases or lambda ratio decreases, the fatigue lives decrease for the various frequencies. Additionally, subsurface failure fatigue lives are reduced as roughness frequency increases regardless of amplitude or Hertzian pressure. The RCF results also indicate that for the low frequency pressure distribution the contact is most susceptible to surface failure, whereas for high frequency pressure distribution the contact resists surface failure. The results from this investigation were used to develop surface roughness effects for various RCF life equations commonly used in rolling element bearing application.

The influence of test lubricants on the rolling contact fatigue failure mechanisms of silicon nitride ceramic

Tribological Characteristics of Silicon Nitride-chilled Cast Iron with Oil-less Lubrication

Analysis on Wear Properties and Impact Factors for Si3N4 Ceramic Mated with Chilled Cast Iron

Subsurface propagation of partial ring cracks under rolling contact: Part I. Experimental studies

Friction and Wear of Self-Mated SiC and Si 3 N 4 in Green Water-Based Lubricant

Subsurface propagation of partial ring cracks under rolling contactPart II. Fracture mechanics analysis

Experimental Study of the Effects of Surface Defects on Rolling Contact Fatigue Behavior

A continuum damage mechanics finite element model for investigating effects of surface roughness on rolling contact fatigue

Rolling contact fatigue failure mechanism of bearing steel on different surface roughness levels under heavy load

The effect of friction on surface crack initiation in rolling contact fatigue considering damage accumulation

Extended crack propagation in nitrided and carburised steels subject to rolling contact fatigue

Wear Characteristics of Nickel/Silicon Carbide Composite Coating in Lubricated Reciprocating Contacts

Experimental investigations to assess surface fatigue failure in rolling contact bearing

Frictional performance of silicon carbide under different lubrication conditions

Analysis and Evaluation of the Synergistic Effect of Ceramic Materials and Surface Texture on Anti-Abrasive Particle Wear under Rolling Conditions

Efficiency of surface texturing in the reducing of wear for tests starting with initial point contact

Effects of carburizing and nitriding sequential treatment on rolling contact fatigue of M50NiL bearing steel

A Study on Decisive Early Stages in White Etching Crack Formation Induced by Lubrication

A study on the of rolling contact fatigue mechanism of ZC-L cast wheel steel

Research on Tribology Property of Si-3N-4 Ceramic and Chilled Iron under Oil-Less Lubrication