Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Prediction of Welding Distortion in A Curved Plate Structure by Means of Elastic Finite Element Method

Theoretical Prediction of Welding Distortion Considering Positioning And the Gap Between Parts

Prediction of Double-Sided Arc Welding Deformation Based on Dynamic Heat Distribution Model and TEP-FE Approach

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Recent Research on Welding Distortion Prediction in Thin Plate Fabrication by Means of Elastic FE Computation

Prediction of welding distortion during assembly process of thin plate structures

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Prediction of Welding Distortions Based on Theory of Inherent Strain by FEM and Its Application

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Numerical Prediction and Mitigation of Out-Of-Plane Welding Distortion in Ship Panel Structure by Elastic Fe Analysis

Numerical simulation on bucking distortion of aluminum alloy thin-plate weldment

Welding Distortion Prediction In 5a06 Aluminum Alloy Complex Structure Via Inherent Strain Method

Study on FEM Numerical Simulation Method for the Welding Distortion

Prediction of deformation of large welding fabrication based on inherent strain

AN FEM MODEL OF BUCKLING DISTORTION DURING WELDING OF THIN PLATE

Evaluation Method for Inherent Deformation and its Application in Predicting Welding Distortion on Hull Blocks

Prediction of Welding Deformation and Residual Stress in A Multiply-Stiffened Plate

Effect of Initial Deflection on Welding Induced Buckling Distortion of Stiffened Plate Structure