Abstract:An integrated aftertreatment system consisting of diesel oxidation catalyst (DOC), catalytic diesel particulate filter (CDPF), and selective catalytic reduction (SCR) is an effective way of reducing both NOx and particulate matter (PM). In this paper, the effect of DOC + CDPF + SCR on NOX and particle emissions is investigated during different operations to assess applicability of this aftertreatment for meeting more rigorous non-road emissions standard. Meanwhile non-negligible issue about regeneration emission is studied. The results show that the DOC + CDPF have no significant effect on NOx but increase the NO2/NOx ratio which is correlated with load. SCR is the main NOx reduction device with average efficiency of 86.5% for steady-state operations. Meanwhile, NH3 slip is lower than 16 ppm. During cold and hot non-road transient cycles (NRTC cycles), average NOx efficiencies are 56.7% and 57.8%, respectively, along with NH3 slip below 10 ppm. DOC + CDPF + SCR maintain filtration efficiency over 97% and 99% for PM and particle number (PN) for either steady-state operation or NRTC cycle, but particle size distributions change. Compared with the original emissions, NOx, PM, and PN emission factors are all below non-road China-IV limit after equipping with DOC + CDPF + SCR. However, during regeneration the aftertreatment does not maintain a high filtration performance but becomes particle generator. The penetration of nuclear particles and decomposition of agglomerated particles lead to high CDPF-out PN of 1.5 × 107 #/cm3–3.5 × 107 #/cm3. During regeneration, accumulated NOx is negligible, but the PM is 121.6 and 44.5 times higher than cold and hot NRTC cycles, respectively. In summary, DOC + CDPF + SCR is excellent way to improve non-road emissions but low SCR efficiency at low-temperature and high accumulated PM during regeneration process should be further addressed.

Application Study of SCR Technology to Diesel Vehicle

Recent Advances in SCR Systems of Heavy-Duty Diesel Vehicles—Low-Temperature NOx Reduction Technology and Combination of SCR with Remote OBD

Diesel Engine SCR Control: Current Development and Future Challenges

Investigation on an Innovative Sorption System to Reduce Nitrogen Oxides of Diesel Engine by Using Carbon Nanoparticle

Comparative Analysis between SCR Dust Characteristic and Cleaning Technology

Review on Selective Catalytic Reduction Technology of Diesel Engines

Study on Diesel Engine Selective Catalytic Reduction Performance at Different Atmospheric Pressures Using the Response Surface Method

The Application and Development of SCR Technology in Coal-Fired Power Plants

NOx emissions from Euro IV busses with SCR systems associated with urban, suburban and freeway driving patterns

An analysis of SCR reactor deactivation impact on NOx emissions from a compression ignition engine

Experimental Research on Aftertreatment SCR Sizing Strategy for a Nonroad Mid–Range Diesel Engine

Study of Control Strategy for Urea-SCR After-Treatment System of Heavy Duty Diesel Engine

Performance Evaluation and Application of Diesel NOx-SCR Catalyst by Ethanol Reductant

Advances in emission control of diesel vehicles in China

An Ethanol SCR for NOx Purification: Performance Evaluation on Engine Bench and Demonstration on Bus

Study on Exhaust Emission and its Control Techniques in Diesel Engine

Investigation On Scr To Reduce Nox Emission

APPLICATION OF SELECTIVE CATALYST REDUCTION (SCR) DENITRIFICATION TECHNOLOGY FOR UTILITY BOILERS

Experimental Study on NOx Reduction of Diesel Engine by EGR Coupled with SCR

Experimental Study of Aftertreatment System Configurations for Euro Ⅵ Heavy-Duty Diesel Engines

An experimental investigation of particle and NOx emissions for a non-road diesel engine equipped with an integrated DOC + CDPF + SCR aftertreatment system during different operations