Abstract:Asynchronous circuits with low power and robustness are revived in emerging applications such as the Internet of Things (IoT) and neuromorphic chips, thanks to clock-less and event-driven mechanisms. However, the lack of mature computer-aided design (CAD) tools for designing large-scale asynchronous circuits results in low design efficiency and high cost. This article proposes an end-to-end bundled-data (BD) asynchronous circuit design flow, which can facilitate building asynchronous circuits, even if the designer has little or no asynchronous circuit foundation. Three features that enable this are: 1) a lightweight circuit converter developed in Python can convert circuits from synchronous descriptions to corresponding asynchronous ones at register transfer level (RTL). Desynchronization flow helps designers maintain a "synchronization mentality" to construct asynchronous circuits; 2) a synchronization-like verification method is proposed for asynchronous circuits so that it can be functionally verified before synthesis. Avoids the risk of rework after logic defects are discovered during the synthesis and implementation, as asynchronous circuits often cannot be simulated until gate-level (GL) netlist generation; and 3) the whole implementation flow from RTL to graphic data system (GDS) is based on commercial electronic design automation (EDA) tools. Similar to the design flow of synchronous circuits, it helps designers implement asynchronous circuits with "synchronization habits." Furthermore, to validate this methodology, two asynchronous processors were, respectively, implemented and evaluated in the TSMC 28-nm CMOS process. Compared to their synchronous counterparts, the general-purpose asynchronous RISC-V processor achieves 20.5% power savings. And the domain-specific asynchronous spiking neural network (SNN) accelerator achieves 58.46% power savings and 2.41x energy efficiency improvement at 70% input spike sparsity.

Design of asynchronous CORDIC and prototyping on FPGA

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

The Design and FPGA Verification of TFT-LCD Timing Controller

Designing Self-timed Asynchronous Circuits with Chisel

Experiment Design of a Synchronous to Asynchronous Converter Based on CPLD/FPGA

Toward Efficient Asynchronous Circuits Design Flow Using Backward Delay Propagation Constraint

Asynchronous Techniques for System-on-Chip Design

A Design Flow for Click-Based Asynchronous Circuits Design with Conventional EDA Tools.

An End-to-End Bundled-Data Asynchronous Circuits Design Flow: from RTL to GDS

A Low-Power Asynchronous RISC-V Processor with Propagated Timing Constraints Method

A Firmware-Based Co-Verification Platform for SoC

Rapid Prototyping and Hardware-In-the-Loop Verification of Enhanced Sliding Mode Control of an Asynchronous Machine Using a Xilinx System Generator and an FPGA-Zynq Board

Design of multi-FPGA-based multi-core processor NoC verification platform

Design And Implementation Of The Configuration Circuit For Fdp Fpga

A Method To Transform Synchronous Pipeline Circuits To Bundled-Data Asynchronous Circuits Using Commercial Eda Tools

Optimize Asynchronous Design by Synchronous Synthesis Tool

Development of Digital Signal Processing Simulation Platform Based on DSP and FPGA Cooperative Processing Technology

Towards Energy-Efficient Asynchronous Circuit Design with Flip-Flop-to-Latch Replacement

Design of Mixed Synchronous/Asynchronous Systems with Multiple Clocks.

A Picosecond Delay Generator Optimized by Layout and Routing Based on FPGA

An Asynchronous Design Method and Its Application on a Low-Power RFID Baseband Processor