Abstract:A significant fraction of the total power in highly synchronous systems is dissipated over clock networks. Hence, low-power clocking schemes are promising approaches for low-power design. We propose four novel energy recovery clocked flip-flops that enable energy recovery from the clock network, resulting in significant energy savings. The proposed flip-flops operate with a single-phase sinusoidal clock, which can be generated with high efficiency. In the TSMC 0.25-$\mu$m CMOS technology, we implemented 1024 proposed energy recovery clocked flip-flops through an H-tree clock network driven by a resonant clock-generator to generate a sinusoidal clock. Simulation results show a power reduction of 90% on the clock-tree and total power savings of up to 83% as compared to the same implementation using the conventional square-wave clocking scheme and flip-flops. Using a sinusoidal clock signal for energy recovery prevents application of existing clock gating solutions. In this paper, we also propose clock gating solutions for energy recovery clocking. Applying our clock gating to the energy recovery clocked flip-flops reduces their power by more than 1000× in the idle mode with negligible power and delay overhead in the active mode. Finally, a test chip containing two pipelined multipliers one designed with conventional square wave clocked flip-flops and the other one with the proposed energy recovery clocked flip-flops is fabricated and measured. Based on measurement results, the energy recovery clocking scheme and flip-flops show a power reduction of 71% on the clock-tree and 39% on flip-flops, resulting in an overall power savings of 25% for the multiplier chip.

Towards Energy-Efficient Asynchronous Circuit Design with Flip-Flop-to-Latch Replacement

A Low-Power Asynchronous RISC-V Processor with Propagated Timing Constraints Method

LAC: A Novel Lightweight Asynchronous Controller with Optimized Phase Shift

Research on low power technology based on Multi Bit Flip Flop

Toward Efficient Asynchronous Circuits Design Flow Using Backward Delay Propagation Constraint

Design of Low Power FlipFlop to Reduce Area and Delay using Conditional Pulse Enhancement Method

Mix & Latch: Comparison With State-of-the-Art Retiming On a RISC-V Benchmark

Clock Controlled Hybrid-latch Flip-Flops Design

A Fast Timing Analysis and Optimization for Latch-Based Circuits

Design of Sequential Elements for Low Power Clocking System

A Coarse-grained Asynchronous Data-Driven Design Flow

A Design Flow for Click-Based Asynchronous Circuits Design with Conventional EDA Tools.

Design of Asynchronous Pipelines for Low-power Microprocessor

The High Performance and Low-Power Circuit Design Based on Pulse Latch

An Asynchronous Bundled-Data Template with Current Sensing Completion Detection Technique

Design of A Low-Power Pulse-Triggered Flip-Flop with Conditional Clock Technique

Better-Than-Worst-Case: A Frequency Adaptation Asynchronous RISC-V Core With Vector Extension

Power-efficient Dual-Edge Implicit Pulse-Triggered Flip-Flop with an Embedded Clock-Gating Scheme.

Design of Flip-Flops with Clock-Gating and Pull-Up Control Scheme for Power-Constrained and Speed-Insensitive Applications.

An Asynchronous Design Method and Its Application on a Low-Power RFID Baseband Processor

Ultra Low-Power Clocking Scheme Using Energy Recovery and Clock Gating