Abstract:A novel simple electrothermal desolvation-enhanced dielectric barrier discharge plasma-induced vapor generation (ETD-DBD-PIVG) method has been developed for sensitive Sb determination by atomic fluorescence spectrometry (AFS). In our proposed ETD-DBD-PIVG, 20 μL sample solution was dried first; then, the resulting solution residue was directly converted into molecular volatile species efficiently through the interactions with hydrogen-doped DBD plasma; and finally, it was transported to AFS for detection. It was found that the desolvation process could greatly enhance Sb vapor generation, and the Sb fluorescence signal intensity is almost independent of its speciation, where comparable sensitivity is achieved for Sb(III) and Sb(V), enabling efficient total Sb detection without pre-reduction. Influencing parameters were evaluated in detail, including heating time, discharge gap, solution pH, and flow rates of argon and hydrogen, as well as coexisting ion interference. Under optimized conditions, the limit of detection was calculated as 0.86 μg L-1 (17.2 pg) for Sb. The accuracy of the proposed method was validated by the analysis of certified reference materials of simulated natural water samples and several river water samples. Compared with conventional hydride generation, the new ETD-DBD-PIVG offers an alternative green vapor generation technique with several advantages: (1) it eliminates the use of a sample flow system (e.g., no use of any syringe or peristaltic pump); instead, 20 μL of a sample is directly pipetted onto the glass plate for analysis; (2) it greatly simplifies the sample pretreatment steps as no pre-reduction process is needed; (3) it is sensitive and suitable for volume-limited sample analysis: efficient Sb vapor generation without chemical reducing reagents in ETD-DBD-PIVG enables Sb detection with an absolute limit at the picogram level. All the results demonstrate that the proposed method provides a simple, green, and sensitive method for Sb determination and it can also be extended to other elements such as Cd and As.

Determination of Tellurium in Refined Antimony Slag by Inductively Coupled Plasma Atomic Emission Spectrometry

Determination of Tellurium in Lead-Tellurium Sediment by Flame Atomic Absorption Spectrometry

Determination of Tellurium in Lead Tellurium Residue Sample by Flame Atomic Absorption Spectrometry

Determination of antimony in water samples by hydride generation coupled with atmospheric pressure glow discharge atomic emission spectrometry

Determination of Trace Phosphorus in Cobalt-Niobium-zirconium Alloy by Inductively Coupled Plasma Atomic Emission Spectrometry

Separation and determination of tellurium(IV) and tellurium(VI) using reversed-phase high-performance liquid chromatography-inductively coupled plasma mass spectrometry

Determination of hydride-forming elements in high purity coppers by inductively coupled plasma atomic emission spectrometry

Analytical Control over the Preparation of Pure Antimony

Study of the Method to Measure Ni,Cu,Fe,Pb and Te in Crude Selenium Materials Using ICP-AES

Determination of Bismuth in Sediment and Soil by Ultrasonic Slurry Sampling Electrothermal Atomic Absorption Spectrometry

Ultra-sensitive determination of antimony valence by solution cathode glow discharge optical emission spectrometry coupled with hydride generation

Electrothermal Desolvation-Enhanced Dielectric Barrier Discharge Plasma-Induced Vapor Generation for Sensitive Determination of Antimony by Atomic Fluorescence Spectrometry

Determination of Antimony by Bianode Electrochemical Hydride Generation-Atomic Fluorescence Spectrometry

Determination of trace rare earth elements in coal fly ash and atmospheric particulates by electrothermal vaporization inductively coupled plasma mass spectrometry with slurry sampling

Determination of antimony in ores and related materials by continuous hydride-generation atomic-absorption spectrometry after separation by xanthate extraction

An Efficient Hydrometallurgical Process for Extracting Tellurium From Copper Telluride Slag

Determination of Mercury in Slag by Spectrophotometry

Determination of Trace Ag, Au, Ge, Pb, Sn and Te by Microwave Plasma Torch Atomic Emission Spectrometry Coupled with an Electrothermal Vaporization Sample Introduction System.

Determination of Pt in biological samples by inductively coupled plasma atomic emission spectrometry (ICP-AES) with electrothermal vaporization (ETV)

Determination of antimony in urine, blood and serum and in liver and lung tissues of infants by inductively coupled plasma mass spectrometry

Determination of bismuth in river sediment by electrothermal atomic absorption spectrometry with low-temperature atomization in argon/hydrogen