Abstract:The behavior of the droplet and the film thickness and temperature distribution of liquid film are critical to heat and mass transfer performance, especially for discontinuous droplet mode. A 3D model was established to capture and illustrate the transient and discontinuous regularity of evolution of droplets. Discontinuous droplet formation and growth account for the majority of the droplet motion cycle, approximately 45-65%. A perceived opposite flow field evolution law was found, where the evolution of the liquid film spreading distance, velocity, and film thickness patterns triggered by the impact of a single discontinuous droplet does not change with the flow rate. The flow rate affected only the flow evolution pattern by modulating the spacing of the discontinuous droplets produced, which decreased with an increasing flow rate. In addition, the typical features of transient droplet behavior such as formation, growth, breakup, detachment, impact and ripple, and fluctuation of spreading film were fully revealed. The corresponding transient characteristics of the spreading distance, velocity, film thickness, and temperature distribution were also formulated. After impact, the velocity of the spreading film started to increase rapidly and then decrease slowly, which could reach a maximum of about 0.6-0.7 m s(-1) within 20 ms. There were two different transient thickness zones: the rapid spreading zone and the stability zone, which showed a sharp increase at a height of about 2000 mu m within 10 ms after the droplet impact and then gradually decreased as the film spread. In addition, the temperature distribution and local evolution regularity mechanism were systematically analyzed, the local high-temperature zone was detected, and its internal formation mechanism was also revealed.

Analysis of LiBr Solution Droplet Falling Film Flow Between Horizontal Tubes

Numerical Simulation on Flow and Heat Transfer of LiBr Solution along the Vertical Wall

Asymmetric Distribution of Falling Film Solution Flowing on Hydrophilic Horizontal Round Tube

Experimental Study on Droplet Flow of Falling Film Between Horizontal Tubes

Numerical simulation of flow characteristics of non-axisymmetric droplet flow between horizontal tubes

Numerical simulation of the behavior of falling films on horizontal plain tubes

Analysis on Wave Flow of Laminar-Wavy Falling Liquid Film

Numerical Simulation of Falling Film and Droplet Absorption Process over and between Horizontal Tubes in Absorber

Experimental and numerical simulation of particle collision and coalescence in a converging tube

The falling, necking, and break-up of droplet between horizontal tubes with low Reynolds number

Characteristic Research on Steam Flowing Across Tubes under the Interaction of Liquid Film and Liquid Droplet

Numerical simulation of falling film evaporation of binary mixture

Investigation on Mass Transfer Characteristics of the Falling Film Absorption of LiBr Aqueous Solution Added with Nanoparticles

The Transient Flow Mechanism and Intermittent Film Thickness Evolution Regulation of Droplet Mode for Horizontal Tube Falling Film

Visualization Study on Liquid Film Flow Pattern in Tubes and V-shaped Mesh Alternating Structure

A Study of Flow Character of Rising Liquid Thin Film on the Spirally Fluted and Ribbed Surface of a Horizontal Tube

Numerical Simulation on Wave Behaviour and Flow Dynamics of Laminar‐wavy Falling Films: Effect of Surface Tension and Viscosity

Discontinuous and Transient Behavior Evolutionary Laws of Flow and Temperature Characteristics of Droplet Mode over a Horizontal Tube Falling Film

Numerical Study of Falling Film Thickness over Fully Wetted Horizontal Round Tube

Experimental Study and Numerical Simulation on Falling Film Thickness Outside a Horizontal Tube

Numerical Model for Liquid Droplet Motion on Vertical Plain-Fin Surface