Abstract:Gas or liquid flow through small channels has become more and more popular due to the micro-electromechanical systems (MEMS) fabrication technologies such as micro-motors, electrostatic comb-drive, micro-chromatographs, micro-actuators, micro-turbines and micro-pumps, etc. The flow conditions in and around these systems are always recognized as typical transitional regimes. Under these conditions, the mean free path of gas molecules approaches the characteristic scale of the micro-devices itself, and due to the little collisions the heat and momentum cannot equilibrate between the wall and fluids quickly. Couette flow is a simple and critical model in fluid dynamics which focuses on the mechanism of the heat transfer in shear-driven micro-cavities or micro-channels. Despite numerous work on the numerical solutions of the Couette flow, how to propose stable and accurate slip boundary conditions in rarefied flow conditions still remains to be elucidated. In this paper, converged solutions for steady-state micro Couette flows are obtained by using conventional Burnett equations with a set of modified slip boundary conditions. Instead of using the physical variables at the wall, the modified slip conditions use the variables at the edge of the Knudsen layer based on a physically plausible assumption in literature that Knudsen layer has a thickness only in the order of a mean free path and molecules are likely to travel without collision in this layer. Numerical results for non-dimensional wall shear stress and heat flux are compared with those of the DSMC solutions. Although there are not much improvement in the accuracy by using this modified slip conditions, the modified conditions perform much better than the unmodified slip conditions for numerical stabilization. All results show that the set of conventional Burnett equations with second order modified conditions are proved to be an appropriate model for the micro-Couette flows.

Simulation of the hydrodynamics and mass transfer in a falling film wavy microchannel

Liquid-liquid Two-Phase Flow and Mass Transfer in T-shaped Micro-Channel Network

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Numerical simulation of oscillatory falling liquid film flows

Numerical Simulation for Two-Dimensional Surface Wave Structure of a Vertical Liquid Falling Film

Numerical Simulation of the Scalar Mixing Characteristics in Three-dimensional Microchannels

Inner circulation flow characteristics of coalescence droplets in microchannel

Hydrodynamics and Liquid–liquid Mass Transfer in Gas–liquid–liquid Three-Phase Flow in a Cross Microchannel

Measurement and theoretical analysis of transient liquid film during micro-channel flow boiling

Experimental and Numerical Study of Mixing Behavior Inside Droplets in Microchannels

Hydrodynamics and Mass Transfer of Liquid-Liquid Two-Phase Flow in Circular Milli-Channels: Sizing-up Effect

Technical Note on the Effect of Lateral Thermal Convection on Freely Falling Liquid Film Flow

Simulation of velocity field inside the droplet in micro-channels by Lattice Boltzmann method

Effect of Viscosity on Liquid–Liquid Slug Flow in a Step T-Junction Microchannel

Bubble/Droplet Formation and Mass Transfer During Gas-Liquid-Liquid Segmented Flow with Soluble Gas in A Microchannel

Effect of interface deformation on hydrodynamics of liquid–liquid two-phase flow in a confined microchannel

Application of CFD Numerical Simulation Image Imaging Technology in the Study of Droplet Microfluidic Multiphase Flow Characteristics

Enhancement of Mass Transfer Performance of Liquid–liquid System by Droplet Flow in Microchannels

μ-LIF visualization and LBM simulation of mixing behavior inside droplets in microchannels

Simulation of liquid mixing inside micro-droplets by a lattice Boltzmann method