Abstract:The reduction of nitric oxide using ammonia combined with methane and pulverized coal additives has been studied in a drop tube furnace reactor. Simulated flue gas with 1000 ppm NO(x) and 3.4% excess oxygen was generated by cylinder gas. Experiments were performed in the temperature range of 700-1200 degrees C to investigate the effects of additives on the DeNO(x) performance. Subsequently, a kinetic mechanism was modified and validated based on experimental results, and a computational kinetic modeling with CHEMKIN was conducted to analyze the secondary pollutants. For both methane and pulverized coal additives, the temperature window is shifted towards lower temperatures. The appropriate reaction temperature is shifted to about 900 and 800 degrees C, respectively with 1000 ppm methane and 0.051 g min(-1) pulverized lignite coal. The addition of methane and pulverized coal widens the temperature window towards lower temperature suggesting a low temperature application of the process. Furthermore, selective non-catalytic reduction (SNCR) reaction rate is accelerated evidently with additives and the residence time to complete the reaction is shortened distinctly. NO(x) reduction efficiency with 80% is achieved in about 0.3s without additive at 1000 degrees C. However, it is achieved in only about 0.2s with 100 ppm methane as additive, and only 0.07 and 0.05s are needed respectively for the cases of 500 and 1000 ppm methane. The modified kinetic modeling agrees well with the experimental results and reveals additional information about the process. Investigation on the byproducts where NO(2) and N(2)O were analyzed by modeling and the others were investigated by experimental means indicates that emissions would not increase with methane and pulverized coal additions in SNCR process and the efficacious temperature range of SNCR reaction is widened approximately with 100 degrees C.

Influence of CH4 additive on SNCR process

Kinetic Study of Promoted SNCR Process by Different Gas Additives

Experimental and Modeling Study of the Effect of CH(4) and Pulverized Coal on Selective Non-Catalytic Reduction Process.

Experimental Investigations of Enhanced Selective Non-catalytic Reduction Reaction with Methane

Calculation and mechnism analysis of sncr process promoted by adding ch4

Numerical Investigation on Promoting Selective Non-catalytic Reduction with Methane Additive by Computational Fluid Dynamics

Experimental Study of the Influences of Additives on Selective Non-catalytic Reduction Process and Ammonia Oxidation

Study on Experiment and Mechanism of Selective Non-catalytic Reduction with Coal Syngas as an Additive

Effect of Methane and Temperature on NO Removal Using by the Selective Non-Catalytic Reduction

Theoretical Study of the Influence of Mixing on the Selective Noncatalytic Reduction Process with Ch4 or H-2 Addition

Chemical Reaction Kinetics Calculation And Analysis Of Sncr Process By Adding Ch4 And Co

Experiment and Mechanism Analysis of Selective Non-Catalytic Reduction with the Compound Reducing Agents in a Lab-scale CFB Reactor

Calculation And Analysis Of Influence Of Coal Gas On Selective Non-Catalytic Reduction Of Nitric Oxide By Ammonia

Experimental Study of the Enhancement of the Selective Noncatalytic Reduction Denitrification Process with Methane and Propane in a Circulating Fluidized Bed

Experimental and Modeling Study on the Influence of H2 Addition on Selective Non-catalytic Reduction Process

Mechanism Validation and Analysis of the Selective Non-catalytic Reduction Reaction with Methane Additive

Experimental and Modeling Study of the Effects of Multicomponent Gas Additives on Selective Non-Catalytic Reduction Process

Influence of Mixing Process on the Selective Non-catalytic Reduction

The effects of Na/K additives and flyash on NO reduction in a SNCR process

Experimental Study and Mechanism Analysis on Selective Non-Catalytic Reduction Reactions

STUDY ON SELECTIVE NON-CATALYTIC REDUCTION PROCESS WITH BIOMASS-GASIFIED GAS ADDITIVES