Abstract:The reduction of nitric oxide using ammonia combined with methane and pulverized coal additives has been studied in a drop tube furnace reactor. Simulated flue gas with 1000 ppm NO(x) and 3.4% excess oxygen was generated by cylinder gas. Experiments were performed in the temperature range of 700-1200 degrees C to investigate the effects of additives on the DeNO(x) performance. Subsequently, a kinetic mechanism was modified and validated based on experimental results, and a computational kinetic modeling with CHEMKIN was conducted to analyze the secondary pollutants. For both methane and pulverized coal additives, the temperature window is shifted towards lower temperatures. The appropriate reaction temperature is shifted to about 900 and 800 degrees C, respectively with 1000 ppm methane and 0.051 g min(-1) pulverized lignite coal. The addition of methane and pulverized coal widens the temperature window towards lower temperature suggesting a low temperature application of the process. Furthermore, selective non-catalytic reduction (SNCR) reaction rate is accelerated evidently with additives and the residence time to complete the reaction is shortened distinctly. NO(x) reduction efficiency with 80% is achieved in about 0.3s without additive at 1000 degrees C. However, it is achieved in only about 0.2s with 100 ppm methane as additive, and only 0.07 and 0.05s are needed respectively for the cases of 500 and 1000 ppm methane. The modified kinetic modeling agrees well with the experimental results and reveals additional information about the process. Investigation on the byproducts where NO(2) and N(2)O were analyzed by modeling and the others were investigated by experimental means indicates that emissions would not increase with methane and pulverized coal additions in SNCR process and the efficacious temperature range of SNCR reaction is widened approximately with 100 degrees C.

Calculation and mechnism analysis of sncr process promoted by adding ch4

The Evaluation of Reactive Sorption Enhanced Biogas Steam Reforming Process for Hydrogen Production Using Nano-Sized CaO Adsorbents.

Calculation and Analysis of Denitration Technology with Hydrocarbons and Ammonia Serving As a Reducing Agent

Experimental Investigations of Enhanced Selective Non-catalytic Reduction Reaction with Methane

Mechanism Validation and Analysis of the Selective Non-catalytic Reduction Reaction with Methane Additive

Experimental and Modeling Study of the Effect of CH(4) and Pulverized Coal on Selective Non-Catalytic Reduction Process.

Numerical Investigation on Promoting Selective Non-catalytic Reduction with Methane Additive by Computational Fluid Dynamics

Experimental and Modeling Study on the Mechanism and Sensitive Parameters of the Thermal DeNOx Process

Experimental and Modeling Study on the Influence of H2 Addition on Selective Non-catalytic Reduction Process

Effect of Methane and Temperature on NO Removal Using by the Selective Non-Catalytic Reduction

The influence of organic components in sludge on selective non-catalytic reduction denitrification

SIMULATION STUDY ON SNCR FOR NOx REMOVAL FROM CHAIN-GRATE FURNACE

CFD analysis of influencing factors on SCR denitration efficiency of sintering flue gas based on response surface methodology

Simulation and Optimization of SNCR Process

Numerical Study of SNCR Process in Coal-Fired Boiler with Large Capacity

Numerical Simulation on Optimization of SCR Denitrification System for Coal-fired Boilers

MODEL TEST AND NUMERICAL ANALYSIS OF FLOW FIELD IN SCR DENITRIFICATION SYSTEM IN SECOND-PHASE PROJECT OF SANHE POWER PLANT

Experimental Study and Mechanism Analysis on Selective Non-Catalytic Reduction Reactions

SELECTIVE REDUCTION DENITRIFICATION OF FLUE GAS BY USING CATALYST Ag/Al2O3 AND REDUCING AGENT C3H6

Experimental Study of the Enhancement of the Selective Noncatalytic Reduction Denitrification Process with Methane and Propane in a Circulating Fluidized Bed

Denitration Simulation of SNCR System Nozzles at Different Layout Positions in Coal Powder Boilers