Abstract:This paper presents a single-stage power management unit to boost and regulate a low supply voltage for CMOS system-on-chip (SoC) applications. It consists of low-leakage, enhanced Dickson charge pump (DCP) that utilizes both stage and frequency modulation (FM) techniques to achieve high efficiency and lower area. In addition, the proposed design uses an enhanced stage-switch structure for the charge pump, which significantly reduces the cross-stage leakage. A stage number controller is used to control the gain of the charge pump by changing the number of stages based on the desired output voltage. FM is utilized to further fine-tune the output voltage through a closed-loop control based on a predetermined reference voltage. Silicon measurement results for the four-stage charge pump in 65-nm CMOS technology show a maximum end-to-end efficiency of 66% at an input voltage of 0.7 V and an output power of <inline-formula> <tex-math notation="LaTeX">$27~\mu \text{W}$ </tex-math></inline-formula>. The proposed design achieved more than a <inline-formula> <tex-math notation="LaTeX">$100\times $ </tex-math></inline-formula> reduction in leakage compared to traditional DCP. The system supports a range of load currents between 0.1 and <inline-formula> <tex-math notation="LaTeX">$34~\mu \text{A}$ </tex-math></inline-formula> with a maximum operating frequency of 1.8 MHz. The proposed system supports an input voltage range of 0.55–0.7 V which makes it an excellent candidate for solar and thermal energy-harvesting applications targeting low-power internet-of-things SOC.

High Efficiency Charge Pump Without Threshold-Voltage Drop

A regulated charge pump with wide current driving capability for low-voltage applications

Design of Charge Pump for High-Speed Phase-Locked Loop

Fully Integrated High-Voltage Level Shifts and Drivers for Buck Converters.

A New Charge Pump with High Voltage Gain for Low Supply Environment

A New Type of Charge-Pump Circuit for Low-Voltage High-Speed PLL Application

A Perfectly Current Matched Charge Pump with Wide Dynamic Range for Ultra Low Voltage Applications

An Improved Charge Pump with High Efficiency for Low Voltage Operations

Diode based charge pump design using 0.35µm technology

Dickson Charge Pump with Gate Drive Enhancement and Area Saving

A High-Efficient, Multi-Phase Charge Pump Scheme

A High Efficiency ALL-PMOS Charge Pump for Low-Voltage Operations

An Efficient, Wide-Output, High-Voltage Charge Pump With a Stage Selection Circuit Realized in a Low-Voltage CMOS Process

A High Efficiency CMOS Charge Pump for Low Voltage Operation

A high-efficiency full-wave CMOS rectifying charge pump for RF energy harvesting applications

A Novel AII-pMOS AC to DC Charge Pump with High Efficiency

An Efficient Nonlinear Charge Pump Cell For Lcd Driver

A Gain-Controlled, Low-Leakage Dickson Charge Pump for Energy-Harvesting Applications

A Step-Up Charge Pump with High Integration and Full-Coverage Voltage Conversion Ratio

Clock Swing Enhanced Charge Pump

Two New Charge Pumps with Improved Reliablity