Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

Preliminary Time Series Analysis of Serrated Yielding in Al-4%Cu Alloy

Temporal Statistical Analysis of Serrated Yielding in Al-Cu Polycrystals

EFFECT OF PRECIPITATE ON PLC EFFECT IN 2024 Al ALLoY

The Portevin-Le Chatelier Effect in Al-Mg Alloy Investigated by Infrared Pyrometry

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Experimental investigations on kinetics of Portevin–Le Chatelier effect in Al–4wt.%Cu alloys

Deformation Measurements of Serrated Yielding Shear Bands in Al-4%Cu Alloy

Influence of Precipitates on the Serrated Yielding in Al-Cu-Mg Alloy and Microscopic Experiment Investigation

Statistical analysis of serrated flows in CoNiV medium-entropy alloy

The Portevin-Le Chatelier (PLC) effect in an Al-Cu aluminum alloy fabricated by selective laser melting

Influence of Nature Aging on Serrated Yielding of 6061 Al-based Alloy

Effect of Solute Concentration on Portevin-Le Chatelier Effect in Al-Cu Alloys

Effect of Solute Atoms and Precipitated Phase in Al-4.5wt% Cu Alloys on the Spatiotempopal Characteristics of the Serrated Yielding

Experimental Study and Mechanism Analysis of the Serrated Plastic Instability of Alloy Materials

Characterization of the deformation behaviors associated with the serrated flow of a 5456 Al-based alloy using two orthogonal digital image correlation systems

Influence Of Solute Concentration On Plc Effect In Al-Cu Alloys

On the spatio-temporal characteristics of the Portevin-Le Chatelier effect in aluminium alloy AA5182: An experimental and numerical study

Multiscale Analysis And Numerical Modeling Of The Portevin-Le Chatelier Effect

Influence of Γ′ Precipitates on the Critical Strain and Localized Deformation of Serrated Flow in Ni-based Superalloys

Numerical Analysis on the Spatiotemporal Characteristics of the Portevin-Le Chatelier Effect in Ti-12Mo Alloy

The Influence of Temperature on the PLC Effect in Al-Mg Alloy