Abstract:Multiple ion-doped lithium manganese oxides LiCr x Ni x Mn 2-2x O 4-z F z (0 < x ≤ 0.25, z = 0.05, 0.1) with a spinel structure and space group Fd 3 m were prepared by using the co-precipitation procedure carried out in water–alcohol solvent using adipic acid as the chelating agent. The electrochemical measurements indicated that the charge/discharge capacities of the samples prepared at 600 °C are higher than that of the treatment at 800 °C or microwave heating. The capacitance-voltage (CV) curves of LiCr x Ni x Mn 2-2x O 4-z F z (0 < x ≤ 0.25, z = 0.05, 0.1) showed that when x ≤ 0.1, the samples had two reduction–oxidation peaks at 4.0 to 4.2-V region, whereas when x > 0.1, the samples had only one reduction–oxidation peak at 4.0- to 4.2-V region in CV measurements and could offer more stable voltage plateau in a 4-V region and also had stable electrical conductivity after 20 cycles. Another reduction–oxidation peak appeared in 4.6-4.8-V region (Ni 2+ –Ni 4+ reduction–oxidation peaks); this suggests that the LiCr x Ni x Mn 2-2x O 4-z F z (0.1 < x ≤ 0.25, z = 0.05, 0.1) cathode material could offer 4.6 to 4.8-V charge/discharge plateaus, and its specific capacity increases with increasing Ni 2+ . The impedance measurements of the cell proved that the F − anion doped can not only prevent Mn 3+ from disproportion but also can prevent the passivation film from forming and can help keep stable the cell’s electrical properties. The LiCr 0.05 Ni 0.05 Mn 1.9 O 3.9 F 0.1 sintered at 600 °C shows the best cycle performance and the largest capacity in all prepared samples; its first discharge capacity is 120 mAh/g, and the discharge capacity loses only 1.78

The synthesis and electrochemical performance of LiMn_(1.95)Cr_(0.05)O_(3.95)F_(0.05)

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Preparation of Submicrocrystal LiMn2O4 Used Mn3O4 As Precursor and Its Electrochemical Performance for Lithium Ion Battery

Synthesis and performance study of Li_(1.1)Ni_(0.35)Mn_(0.55)O_2 cathode material of lithium-ion batteries

Co-precipitation synthesis and performance of multi-doped LiCr x Ni x Mn 2-2x O 4-z F z cathode materials for lithium ion batteries

Synthesis and Physicochemical Properties of LiLa0.01Mn1.99O3.99F0.01 Cathode Materials for Lithium Ion Batteries

Synthesis and Performance of Cathode Material for High Voltage Li-ion Batteries

Investigation on LiNi0.5Mn1.5O4 cathode material based on the precursor of nickel-manganese compound for lithium-ion battery

Structural and electrochemical characterization of LiMn2-2xLixNixO4 (0 <= x <= 0.1) cathode materials

Synthesis of cathode material LiNi_(1/3)Co_(1/3)Mn_(1/3)O_2 and its electrochemical performances

Electrochemical performance of LiMn2O4 synthesized from precursor Mn3O4

One-step Synthesis and Effect of Heat-Treatment on the Structure and Electrochemical Properties of LiNi0.5Mn1.5O4 Cathode Material for Lithium-Ion Batteries

Electrochemical Performance of LiMn_(2-x)Co_xO_4 Cathode Materials Synthesized by a Co-Precipitation Method

Controllable synthesis of spinel lithium nickel manganese oxide cathode material with enhanced electrochemical performances through a modified oxalate co-precipitation method

Synthesis and Electrochemical Properties of Li[Mn1/3-x/3 Ni1/3-x/3 Co1/3-x/3 Crx ]O2 As Cathode Materials for Lithium-ion Secondary Batteries

Synthesis and electrochemical performance of LiNi_(1/3)Mn_(1/3)Co_(1/3)O_2-zFz cathode materials for lithium ion batteries

High capacity Li1.1Mn2O3.95F0.05 cathode materials for Li-ion rechargeable battery

Synthesis and Characterization of LiNi1/3Mn1/3Co1/3O2 by Wet-Chemical Method

Synthetic Optimization and Electrochemical Properties of LiNi_(0.5)Mn_(0.5)O_2 Cathode Materials for Lithium-ion Batteries

Synthesis, Characterization and Electrochemical Performance of Li[Li0.2Mn0.54Ni0.13Co0.13]O2cathode Materials for Lithium-Ion Batteries

Electrochemical Performance Ni Doped Spinel LiMn2O4 Cathode for Lithium Ion Batteries