Abstract:The calculations of the temperature fields, the residual stress distributions and the displacement distributions of welding process by using three-dimensional thermo-elastic-plastic FEM (finite element method) are time-consuming. Some high efficiency computational methods aiming at characteristics of welding process in welding process numerical simulation were proposed such as segmented moving heat source, adaptive mesh technique, similitude principles, special transition element, material modeling at high temperature and parallel computation etc. It has proved that using one method mentioned above can reduce the solution time of welding process numerical simulation. In this paper a butt weld of a thin aluminum plate is investigated by means of three-dimensional thermo-elastic-plastic FEM on the basis of commercial software ABAQUS. Four schemes are carried out for achieving the calculation efficiency of different schemes: (a) moving heat source with solid element; (b) segmented moving heat source with solid element; (c) moving heat source with shell to solid transition; (d) segmented moving heat source with shell to solid transition. The simulated results show that although in the weld zone the residual stress distributions have some difference, the residual stress distributions are very close away from weld zone for four schemes. The comparison of the computational time for the four schemes indicates that segmented moving heat source with shell to solid transition not only can reduce the calculation time but also can improve the efficiency of modeling process compared to the other schemes.

Simulation on TIG Welding of Aluminum Alloy Plate and Residual Stress Predicting

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Finite Element Prediction of Residual Stress and Deformation Induced by Double-Pass TIG Welding of Al 2219 Plate

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Finite element simulation of welding process and real-time monitoring assessment

3D-FEM numerical simulation of welding stress in thin aluminum alloy plate

Finite Element Analysis of Residual Welding Stresses and Deformation for a 5A06 Aluminum Alloy Plate

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Numerical Simulation of Residual Stresses in Multipass Gas Metal Arc-Welded Joints of Thick Aluminum Alloy Plates

Numerical Simulation and Weld Morphology of 5056 Aluminum Alloy TIG Welding

Welding Numerical Simulation Analysis of AP 1000 Insert Plate and Penetration Sleeves Based on ABAQUS

Numerical Simulation on Residual Stress in T-joint Weld Toe Remelted by TIG

Numerical Simulation of Tungsten Inert Gas Welding of 5A12 Aluminum Alloy Limited Size Sheet

Simulation of Temperature and Stress Fields of 2060Al-Li Alloy in FSW Process

Finite element simulation of temperature field for TIG butt welding of thin plate

Effect of Thermophysical Parameters on the Hump Feature of Welding Residual Stress by Finite Element Analysis

3D Numerical Simulation of Brazed Residual Stress in Stainless Steel Plate-Fin Structure

Numerical Simulations of Welding Residual Stresses in VPTIG-welded Joints of the 2219 Aluminum Alloy

Numerical Simulation of the Residual Stress in Laser Beam Welded and TIG Welded Joints of Thin Plate of Titanium Alloy

Sensitivity Analysis of Some High Efficiency Computational Methods for Welding Process Numerical Simulation