Abstract:Modeling metal matrix composites in finite element software requires incorporating a cohesive zone model (CZM) to represent the interface between the constituent materials. The CZM determines the behavior of traction-separation (T-S) in this region. Specifically, when a diffusion zone is formed due to heat treatment, it becomes challenging to determine experimentally the equivalent mechanical properties of the interface. Additionally, understanding the influence of heat treatment and the creation of a diffusion zone on the T-S law is crucial. In this study, the molecular dynamics approach was employed to investigate the effect of the diffusion region formation, resulting from heat treatment, on the T-S law at the interface of a SiC/Al composite in tensile, shear, and mixed-mode loadings. It was found that the formation of a diffusion layer led to an increase in tensile and shear strengths and work of separation compared with the interfaces without heat treatment. However, the elastic and shear moduli were not significantly affected by the creation of the diffusion layer. Moreover, the numerical findings indicated that the shear strength in the diffusion region was higher when compared with the shear strength of the {111} slip plane within the fcc aluminum component of the composite material. Therefore, in the diffusion region, crack propagation did not occur in the pure shear loading case; however, shear sliding was observed at the aluminum atomic layers.

Effect of the interfacial reaction layer thickness on the thermal residual stresses in SiCf/Ti–6Al–4V composites

The Effects of Thermal Residual Stresses and Interfacial Properties on the Transverse Behaviors of Fiber Composites with Different Microstructures

Effects of interfacial residual stress on mechanical behavior of SiCf/SiC composites

Thermal residual stress in continuous SiC fiber reinforced titanium matrix composites

Evaluation of Weak Interface Effect on the Residual Stresses in Layered SiC/TiC Composites by the Finite Element Method and X-Ray Diffraction

Effects of Interfacial Residual Stress on Mechanical Behavior of SiC F /sic Composites

Residual stress variation in SiCf/SiC composite during heat treatment and its effects on mechanical behavior

Residual stress analysis in the Al2O3/Ti 3SiC2 multilayer composites

Numerical Analysis of the Effects of Reinforcing Particles on the Residual Stress of TiB2/Al-Si Composites Fabricated by Laser Powder Bed Fusion

Evaluation of Interfacial Properties in SiC Composites Using an Improved Cohesive Element Method

Micromechanical Analysis of SiC/Ti6Al4V Composite Under Complex Stress State

Experimental study of residual stress distribution in interfacial micro-region of SiC f /Ti17 composites via micro-slotting method

A Study of the Residual Stress and Its Influence on Tensile Behaviors of Fiber-Reinforced Sic/Al Composite

Determination of interfacial residual stresses in SiC(f)/Ti-22Al/26Nb composites using raman spectroscopy

The oxide-layer configuration alteration and pseudo-ductile crack propagation mechanisms in composites induced by different relative thicknesses of CVI HfC-SiC multiphase matrix

Residual Stresses and Mechanical Properties of Si 3 N 4 /sic Multilayered Composites with Different SiC Layers

Study of Interfacial Stress Distribution in SiC Fiber Reinforced Titanium Matrix Composites on Transverse Tensile Tests

Finite Element Analysis of Thermal Residual Stress in Unidirectional Fiber Reinforced Composite

Investigating the Influence of Diffusion on the Cohesive Zone Model of the SiC/Al Composite Interface

Fabrication and properties of SiC/Si 3 N 4 multilayer composites with different layer thickness ratios by aqueous tape casting

Effect of thermal residual stress on the tensile properties and damage process of C/SiC composites at high temperatures