Abstract:Ultrasonic-assisted plastic micro-forming is a research hotspot in metal-forming process. The friction characteristic is a key factor affecting the micro-forming properties of metal in ultrasonic-assisted micro-forming process. However, the existed researches were mostly focused on the friction characteristics of free surfaces, while few were studied on the friction characteristics between sample and mold cavity. In this paper, the micro double cup extrusion experiments of copper T2 were conducted to investigate the friction characteristics between sample and mold cavity with multiple ultrasonic vibration modes. Furthermore, the numerical model was developed to quantify the friction stress reduction caused by multiple ultrasonic vibration modes and estimate its contribution to decreasing the forming stress, which was usually considered mainly affected by acoustic softening, stress superposition, and friction reduction. The results show that the forming stress and the surface roughness of extruded samples are decreased sequentially with the multiple ultrasonic vibration modes of tool vibration (TV), workpiece vibration (WV), and compound vibration (CV). The cup height ratios of double cup extrusion are also increased sequentially with the ultrasonic vibration modes. But the increase of cup height ratio does not indicate the increase of friction coefficient. The friction stress reduction between sample and mold cavity is increased sequentially with TV, CV, and WV modes, and its contribution to decreasing the forming stress is 48%, 15%, and 49%, respectively.

Effects of friction conditions on flow stress fluctuation in micro-upsetting

Effects of superimposed high-frequency vibration on deformation of aluminum in micro/meso-scale upsetting

Effect of the Friction on the External High Pressure Forming of Metal Stator Screw Lining

EXPERIMENTAL STUDY OF STRESS EFFECT ON PEAK FRICTION ANGLE OF ROCK STRUCTURAL PLANE

Effects of Normal Stress, Surface Roughness, and Initial Grain Size on the Microstructure of Copper Subjected to Platen Friction Sliding Deformation

Effects of Fiber Diameter and Tribotest Conditions on Nonlubricated Frictional Behavior of a Microsized Metal Fiber

Friction correction of flow stress-strain curve in the upsetting process

Effect of surface roughness on sliding friction in lubricated contacts-reciprocal experiment study

Evaluation of Rheological Behavior and Interfacial Friction under the Adhesive Condition by Upsetting Method

Deformation Behavior and Microstructural Evolution of T-Shape Upsetting Test in Ultrafine-Grained Pure Copper

Transition of frictional states and surface roughness effects in lubricated contacts

An investigation on the friction in a micro sheet metal roll forming processes considering adhesion and ploughing

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Effects of Load and Relative Humidity on Micro-friction

Analysis of Metal Deformed Flow under Adhesive Friction by Ring Upsetting

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Variations in strain affect friction and microstructure evolution in copper under a reciprocating tribological load

Evaluation of friction reduction and frictionless stress in ultrasonic vibration forming process

Experimental and numerical studies of relationship between microstructures and mechanical properties in friction stir welding under water

Investigation on friction characteristics of micro double cup extrusion assisted by different ultrasonic vibration modes

Investigation of Interfacial Friction and Inverse Flowing Behavior under the Adhesive State