Abstract:Light detection and ranging (LiDAR) is the most important active remote sensing tool and is widely used in civilian and military fields. There are a number of methods to drive laser diodes; the most common circuit topologies are capacitor-discharge resonant circuits. However, the performance of the silicon (Si)-based switching device limits the development of Light detection and ranging, such as the large figure of merit (FOM) and the stray inductance. Although different methods have been reported to resolve these problems, there are still great challenges in reducing the pressure on Light detection and ranging driver design. Hence, this work presents a gallium nitride (GaN)–Si hybrid integrated driver for a Light detection and ranging system. In the circuit, the switching power device uses GaN instead of a Si-based device, because GaN enables much better performance for pulsed-laser operation due to its near-ideal switching performance. Furthermore, a GaN push–pull driver stage between the GaN power device and the Si-based driver integrated circuit (IC) was innovatively introduced, which is integrated in the same chip with the GaN power device, thereby effectively reducing the parasitic parameters of the signal chain and enhancing the system reliability. The design and implementation of the Si-based IC and GaN IC are based on 0.18 μm 80–120 V Bipolar-CMOS-DMOS (BCD) technology and 0.5 μm p-GaN technology, respectively. The experimental results suggest that the proposed driver circuit output pulse width is 12.6 ns, and it can normally operate at 10 MHz with turn-on/turn-off delay is 11.94 ns. In addition, the driver was capable of generating approximately 8.25 A current pulses through a low ohmic load with a pulse width of approximately 12.4 ns. This work plays a vital role in promoting the development of information equipment and aerospace equipment such as precise ranging, high-efficiency power supplies, and high-speed motors.

Design of LD Current Drivers of Pump-Modules in Fiber Amplifiers

Design and Implementation of a Power Semiconductor-Based Switching Mode Laser Diode Driver

200 Gb/s Optical-Amplifier-Free IM/DD Transmissions Using a Directly Modulated O-Band DFB+R Laser Targeting LR Applications

DC～3 Gb/s LD/EA Drivers Using Discrete Double Polysilicon Bipolar Transistors

A Kind of High Bit Rate Laser Diodes Driver

A Load-Adaptive Driving Method for a Quasi-Continuous-Wave Laser Diode

An Efficiency Improvement Driver for Master Oscillator Power Amplifier Pulsed Laser Systems

Design of High-Performance Driving Power Supply for Semiconductor Laser

Analysis and Design of High-Accuracy Driving Circuit for Wideband Phase Modulators

An Adjustable Amplitude And Pulse-Width Laser Modulation Driver With Active Feedback For Qkd Experiments

Laser diodes semicircular side-pumped laser rod with a round-sharped output

Design and fabrication of >20 KW 5 × 1 pump combiner with high efficiency

A laser source driver in 0.18 <i></i>m SiGe BiCMOS technology for high speed quantum key distribution

High - Efficiency Laser Diode Arrays Pumped Nd: YAG Laser

An Ultra-High Stability, Low-Noise Laser Current Driver with Digital Control

2.5Gb/s 1.55 μm InGaAsP/InP DFB laser/electroabsorption modulator integrated device

A GaN–Si hybrid integrated driver for narrow-pulse and high-current LiDAR applications

A laser source driver in 0.18 μm SiGe BiCMOS technology for high speed quantum key distribution

Cost-Effective Partially Corrugated Waveguide Laser Diodes for Use in Optical Access Networks

Single-drive High-Speed Lumped Depletion-Type Modulators Toward 10 Fj/bit Energy Consumption