Abstract:This study presents a detailed investigation into the deformation behaviour and the factors affecting the strength and ductility of laser powder bed fusion (LPBF) Ni-based superalloy 718 (Inconel 718) in both as-printed and heat-treated conditions using in-situ SEM + EBSD. The results show that following post-deposition high homogenization temperatures, the columnar grain structure of the as-printed Inconel 718 alloy successfully transformed to a nearly uniform grain size and the subsequent aging processes facilitated the precipitation of strengthening phases (gamma ', ' , gamma"). The specimen subjected to heat treatment (HT1) exhibited higher strength but lower ductility, while the as-printed specimen shows higher tensile elongation due to high initial dislocation density. In contrast, the heat-treated (HT2) specimen presented a more optimal combination of strength and ductility. The underlying mechanism for the enhanced tensile properties in the HT2 specimen was nearly homogeneous deformation trend across the grains and ultrafine precipitation of hardening phases. In addition, the twin boundaries were stable in the early deformation stages and maintained their orientation. Multiple slip systems were activated at the high-deformation stage, resulting in a high proportion of geometric necessary dislocations. Further, the interaction of deformation-induced dislocation with twin boundaries transformed them into general boundaries such as high and low-angle grain boundaries, ultimately increasing ductility. On contrary, in the HT1 specimen, the deformation inhomogeneity in grains enabled the strain localization at grain boundaries, which ultimately caused the early formation of cracks.

Evaluation of new Ni-based superalloy prepared by EB-PVD

Research on Sheet Metal of a New Ni-Based Superalloy Prepared by EB-PVD

Structures and mechanical properties of Ni-Co-Cr based superalloy prepared by technique of EB-PVD

Microstructure and Properties of Ni-Based Superalloy Sheet Prepared by Eb-Pvd

Preparation and investigation of superalloy sheet by EB-PVD

Mechanical Properties and Fracture Behavior of Laser Powder-Bed-Fused GH3536 Superalloy

Sintering and microstructure evolution of columnar nickel-based superalloy sheets prepared by EB-PVD

Preparation and Mechanical Properties of Ni-Cr-Al Alloy by Eb-Pvd

Effect of Aging Heat Treatment on Microstructure and Mechanical Properties of EB-PVD Ni-Based Alloy Sheet

Microstructures and mechanical properties of a NI-CR-AL alloy by EB-PVD

Research on Microstructure of Ni-20.3Cr-4.6Co-2.1Al As-deposited State Sheet Prepared by EB-PVD

Insight into Elongation and Strength Enhancement of Heat-Treated LPBF Ni-based Superalloy 718 Using In-Situ SEM-EBSD

Microstructure Evolution of Electron Beam Physical Vapour Deposited Ni-23.5Cr-2.66Co-1.44Al Superalloy Sheet During Annealing at 600 °C

Effect of heat treatments on the microstructure and mechanical properties of IN738LC prepared by electron beam powder bed fusion

Microstructure and mechanical properties of ODS Ni-based superalloy foil produced by EB-PVD

Effect of Heat Treatment on Microstructure and Mechanical Properties of Inconel 625 Alloy Fabricated by Pulsed Plasma Arc Deposition

Research of Oxidation Resistance about ODS Ni-based Superalloy Prepared by EBPVD

Intermediate temperature creep and deformation behavior of a nickel-based superalloy prepared by electron beam layer solidification

Microstructure and Mechanical Properties of Novel Nickel-Based P/M Superalloy

Microstructures and homogenization behavior of a nickel-based superalloy used for 850¬Ý‚ÑÉ turbine disc prepared by electron beam smelting layered solidification

Mechanical Properties and Oxidation Formation of Eb-Pvd Deposited Ni-Cr-Al Alloy