Abstract:In this work, the RAFM steels EUROFER, RUSFER and CLAM, along with a reference pure Fe sample, were all exposed to the same source of deuterium and analyzed using the same techniques, allowing a direct comparison of the experimental results. A 200 eV/D mass-selected deuterium ion beam at the SIESTA facility was used to bombard the samples to a fluence of 5 × 1024 D m−2 at 450 K. The surface morphology of the samples was investigated with Scanning Electron Microscopy. The sputter yield of the samples was determined by weight-loss measurements and confirmed by measurements of the eroded depth. The near-surface enrichment of W and Ta was investigated via Energy-dispersive X-ray spectroscopy, X-ray Photoelectron Spectroscopy and Rutherford Backscattering Spectrometry. Grain-orientation-dependent sputtering was studied with Confocal Laser Scanning Microscopy and Electron Backscatter Diffraction. Lastly, Nuclear Reaction Analysis and Thermal Desorption Spectrometry were employed to analyze deuterium retention in all the samples. The erosion behavior of all three steels under deuterium bombardment was confirmed to be similar. The measured sputter yield was comparable for all three steels, and significantly lower than that of pure Fe. Likewise, all steels develop a needle-like surface morphology under the given exposure conditions and a W- and Ta-enriched layer in the range of few nanometers, while the Fe sample remained smooth. Retained deuterium amounts were also comparable among the steel samples, and were overall larger than the retention measured for the pure Fe sample.

Measurement of backward sputtering yields induced by fast neutrons

Backward Sputtering Induced by Fast Neutron

SPUTTERING RESEARCH OF Al-50wt％Sn ALLOY

Study of ion sputtering on AlxSn100-x alloy system

The Sputtering of Radioactive Recoil Nuclides Induced by Fast Neutron

Reduced Sputtering Yields Induced By Fast Neutrons

Surface erosion of materials induced by fast neutron sputtering

Analysis of Sputtering Yield Measurements for Ion Thruster Grid Materials

Forward and Backward Secondary Electron Emission from Carbon Foils by O2+ Ion

Measurement of Neutron-Induced Fission Cross Sections of 235U and 238U Relative to N-P Scattering at CSNS Back-n Facility

Secondary Electron Emission from Carbon Foils by Ne2+ Near Bohr Velocity

Comparison Experiment on the Sputtering of EUROFER, RUSFER and CLAM Steels by Deuterium Ions

Investigations of reactivity worth measurement in a fast neutron reactor with the inverse kinetics method

The influence of target film material and coating on neutron yield and sputtering yield

The Research on the Suppression of Spurious Neutrons for A Neutron Detector Array That May Be Used in the Neutron Scattering

Measurement of the cross section for neutron energies from 0.4 MeV to 40 MeV from the back-streaming white neutron beam at the China Spallation Neutron Source

Measurement of Prompt Neutron Decay Constant on Uranium-Plutonium Metal Assembly

New Measurements and Quantitative Analysis of Electron Backscattering in the Energy Range of Neutron Beta-Decay

Measurement of the U-236,U-238(n,f) cross sections from the threshold to 200 MeV at CSNS Back-n

Measurements of effective delayed neutron fraction in a fast neutron reactor using the perturbation method

Initial Years' Neutron-Induced Cross-Section Measurements At The Csns Back-N White Neutron Source *