Abstract:A millisecond mixing process for liquids was implemented using a new mixer design, i.e., a jet nozzle connected with a trumpet-shaped module. The jet nozzle can facilitate two or three liquid channels, performing an initial impingement mixing of liquid sheets in the thickness at millimeters. Then, the joint liquids sheet out of the jet nozzle was stretched thinner and thinner on the expanded solid surface of the trumpet-shaped module, which significantly intensified the liquid mixing process. Accordingly, dual controls on the liquid mixing can be accomplished flexibly by optimizing the operating conditions and the module configuration. Experiments were carried out to investigate the influencing factors on the mixing performance, where the planar laser induced fluorescence (PLIF) technique was used to measure the mass transport of fluorescent dye between the liquids. The intensity of segregation (IOS) and 95% mixing time (τ95) were employed to characterize the mixing performance. The results showed that the module with a greater curvature surface possessed a better mixing performance owing to the rapid reduction of the liquid sheet thickness, which strengthened the mixing process in the lateral direction along the flow development. The mixing behaviors are greatly influenced by the flow rate ratio between the liquids. An optimum mixing state could be achieved when QS1/QS2 is 1:1. An increase of QT under the same flow rate ratio does not affect the mixing pattern in space, but the corresponding τ95 is almost linearly shortened. By splitting one liquid stream into two surrounding streams, the so called Sandwich operation brought further improved mixing performance compared with the two liquids mixing process. Using the novel jet nozzle design, millisecond(s) mixing of liquids can be easily achieved with flexible control.

Study of Fast Liquid-Liquid Micromixing Using PLIF Technique

Millisecond Mixing of Two Liquid Streams in a Mixer Model

Measurement of Temperature Field in a Fast Liquid-Liquid Mixing Process by PLIF

Fast liquid mixing by cross-flow impingement in millimeter channels

Liquid-liquid Two-Phase Flow and Mass Transfer in T-shaped Micro-Channel Network

Study on the mixing behavior of thin liquid-sheet impinging jets using the PLIF technique

Fast Liquid Jet Mixing in Millimeter Channels with Various Multislits Designs

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Study on the reactive mixing process in an unbaffled stirred tank using planar laser-induced fluorescence (PLIF) technique

Experimental Study of Turbulent Mixing in A Tee Mixer Using Piv and Plif

Visualization of reactive and non-reactive mixing processes in a stirred tank using planar laser induced fluorescence (PLIF) technique

Application of laser-induced fluorescence technique in visualization of liquid mixing process

EFFECTS OF INLET ARRANGEMENTS ON LIQUID-LIQUID FLOW PATTERNS IN CROSS-JUNCTION SQUARE MICROCHANNELS

Visualization of Gas-Liquid Mass Transfer and Reaction Using Laser Induced Fluorescence Technique

Experimental study of reactive mixing in a mini-scale mixer by laser-induced fluorescence technique

Millisecond mixing of liquids using a novel jet nozzle

Analysis on Chaotic Mixing Inside a Plug and Determination of Lagrangian Velocity

Experimental study on the dispersed phase macro-mixing in an immiscible liquid–liquid stirred reactor

Visualization Of Coupled Mass Transfer And Reaction Between Gas And A Droplet Using A Novel Reactive-Plif Technique

Intensification of Viscous Fluid Mixing in Eccentric Stirred Tank Systems

μ-LIF visualization and LBM simulation of mixing behavior inside droplets in microchannels