Abstract:Activation is a important process before a PEMFC produces electricity stably. A good activation process could not only discloses the performance of a newly fabricated PEMFC to its maxim, but also guarantee to reproduce the same performance at the same working point, which is important when researching a fuel cell. In this paper, a three-step activation process will be introduced, i.e. for the first step, the MEA was activated with a higher cell temperature (70) and a normal humidification temperature (60) for both the anode and cathode side; for the second step; the MEA was activated with a higher humidification temperature (70) and a normal cell temperature (60) for both the anode and cathode side; finally, the cell was operated with a normal cell temperature (60) and a normal humidification temperature (60) for both the anode and cathode side. During the activation, a cooling-after-a-stop method was used, which means the cell was cooled to a room temperate every time after a testing round. It was found the performance of a new testing round could be increased after a cooling-after-a-stop when compared to that of a old round. Furthermore, the performance of a PEMFC with a three-step activation process could be increased around 4% at 400mA/cm 2, and the maxim current could be increased from 40A (1.6A/cm 2)to 45A (1.8A/cm 2; a increase of 12.5%) when compared to a common one-step process (i.e. the cell temperature and the humidification temperature were all kept at 60) during the same testing span. Phenomena will be analyzed and some hypothesis will be put forwarded to explain the phenomena. However, a detailed research, e.g. CV, EIS and visualization, should be made in the future.

The performance and mechanism of multi-step activation of MEA for DMFC

Development of Cathode Ordered Membrane Electrode Assembly Based on TiO2 Nanowire Array and Ultrasonic Spraying

Alteration of the Membrane Electrode Assemblies during Direct Methanol Fuel Cell Activation Process

A novel MEA architecture for improving the performance of a DMFC

Disclosure of the Internal Mechanism During Activating a Proton Exchange Membrane Fuel Cell Based on the Three-Step Activation Method

Effects of MEA preparation on the performance of a direct methanol fuel cell

Development of Membrane Electrode Assembly for Direct Methanol Fuel Cells

Effect of Different Hot-Pressing Pressure and Temperature on the Performance of Titanium Mesh-Based MEA for DMFC

Optimization of Membrane Electrode Assembly in Air-Breathing Direct Methanol Fuel Cell

Performance of an integrated composite membrane electrode assembly in DMFC

Preparation of an Integrated Membrane Electrode Assembly for Proton Exchange Membrane Fuel Cells Using a Novel Wet-Bonding Strategy

Initial research on the activation process for a PEMFC: Phenomenon analysis

Investigation of a New Method to Prepare Low Methanol and Water Crossover Membrane Electrode Assembly for Passive Direct Methanol Fuel Cells

An Asymmetric Membrane Electrode Assembly for High-Performance Proton Exchange Membrane Fuel Cells

Critical materials and technology in direct methanol fuel cells

Influence and Improvement of Membrane Electrode Assembly Fabrication Methods for Proton Exchange Membrane Water Electrolysis

Enhanced MEA Performance for an Intermediate-Temperature Fuel Cell with a KH5(PO4)2-Doped Polybenzimidazole Membrane

A High-Performance Membrane Electrode Assembly with an Ultrathin Proton Exchange Membrane Based on a Wet-Combining Interface Forming Strategy

A Novel Self-Humidifying Membrane Electrode Assembly with Water Transfer Region for Proton Exchange Membrane Fuel Cells

Effect of membrane deposition methods on the performance of membrane electrode assemblies

Effects of Hot Pressing Conditions on the Performances of Meas for Direct Methanol Fuel Cells