Effects of Hot Pressing Conditions on the Performances of Meas for Direct Methanol Fuel Cells

Jian Zhang,Ge-Ping Yin,Zhen-Bo Wang,Qin-Zhi Lai,Ke-Di Cai
DOI: https://doi.org/10.1016/j.jpowsour.2006.12.039
IF: 9.2
2007-01-01
Journal of Power Sources
Abstract:The effects of hot pressing conditions (hot pressing temperature, pressure and time) on the performances of membrane electrode assemblies for direct methanol fuel cells were investigated. The performances of membrane electrode assemblies (MEAs) were characterized by the polarization curves and electrochemical impedance spectra (EIS). The surface morphologies of the electrodes were observed by scanning electron microscopy (SEM). The compression ratios of electrodes were determined by testing the thicknesses of the anodes and the cathodes before and after the hot pressing process. The MEA which was hot pressed at 135°C under 80kgcm−2 for 90s, showed the highest power density of 46.0mWcm−2 at 80°C and ambient pressure. As the hot pressing temperature, pressure and time increased, the compression ratios of the anodes and cathodes increased, and the activating time required for MEA to reach optimum performance increased, too. The cell resistances of the MEAs hot pressed at higher hot pressing temperature (135°C) and pressure (120kgcm−2), or for longer time (90s), decreased because of the good contact between the membrane and electrodes. The MEAs that were hot pressed under higher temperature (135°C) and higher pressure (120kgcm−2) benefited for long-time cell operating.
What problem does this paper attempt to address?