Abstract:The solid-state processing and utilization of light-metal-based composites align with green policies by reducing the weight of components and employing lower processing temperatures compared to traditional metallurgical methods. This study explores the incorporation of SiC particles at concentrations of 5 and 10 wt.% into an Al4Cu matrix through powder mixing, compaction at 235 MPa, hot extrusion, and sintering at 600 °C in a nitrogen atmosphere. The resulting microstructure, hardness, compressive strength, and flexural strength of the composites were evaluated. During extrusion, the composite underwent plastic deformation, leading to cracking and fragmentation of the SiC particles within the matrix. Therefore, evenly distributed reinforcing particles with a diameter much smaller than the originally introduced ceramic particles were observed. Recrystallization also occurred, with Al 2 Cu precipitates forming on grain boundaries and nanosized Al 2 O 3 oxides observed in porous areas and at matrix-reinforcement interphase boundaries. The composite containing 5 wt.% SiC exhibited the highest compressive strength of 305 MPa, while the composite with 10 wt.% SiC achieved the highest flexural strength of 889 MPa. However, non-deformable SiC particles crack before reaching maximum strength due to stress concentration at their sharp edges, initiating microcracks in the matrix. Microstructural analysis further revealed that SiC particles tend to crack during hot extrusion, reducing their effectiveness in stress transfer. The hardness remained constant at 78 HV1, irrespective of SiC content. These findings demonstrate that the addition of SiC particles significantly enhances the mechanical properties of Al4Cu composites, making them promising materials for lightweight and high-strength applications.

Electrical Behavior of SiCp Reinforced Copper Matrix Composites by Hot Pressing

Microstructure and Properties of In-Situ TiC Reinforced Copper Nanocomposites Fabricated Via Long-Term Ball Milling and Hot Pressing

Long-term Ball Milling and Hot Pressing of In-Situ Nanoscale Tungsten Carbides Reinforced Copper Composite and Its Characterization

Processing copper and silver matrix composites by electroless plating and hot pressing

Mechanical properties of Cu/SiCp composites fabricated by composite electroforming

Study on composite electroforming of Cu/SiCp composites

Effect of sintering temperature on microstructure and properties of nano-WC particle reinforced copper matrix composites prepared by hot-pressing sintering

Effects of Process Parameters on Microstructure and Properties of TiC Reinforced Cu-Matrix Composites

Hot extrusion of SiCp/Al-Cu composites: optimizing mechanical properties through microstructural control

Structure Formation in Silicon Carbide–Alumina Composites during Electroconsolidation

Study of Hot-press Sintering Process of Nanometer Cu-Al_2O_3 Composite

Hot isostatic pressing of SiC particulate reinforced metal matrix composites

Enhanced Mechanical/electrical Properties of in Situ Synthesized SiC-TiB2 Ceramic Composites by Reactive Hot-Pressing Sintering

New Preparation Technology of Copper Matrix Composites Reinforced by Short Carbon Fibers

Sintering of SiC enhanced copper paste for high power applications

Preceramic Paper-Derived SiCf/SiCp Composites Obtained by Spark Plasma Sintering: Processing, Microstructure and Mechanical Properties

Study on the Performance for Silicon Carbide Ceramics by Hot-pressing Sintering

Enhanced mechanical and electrical properties of novel graphene reinforced copper matrix composites

Hot Workability of the Multi-Size SiC Particle-Reinforced 6013 Aluminum Matrix Composites

Effect of Hot-Pressing Pressure on the Microstructure and Thermal Conductivity of Copper/Ti-Coated Diamond Composites

Processing and Properties of ZrB2-Cu Composites Sintered by Hot-Pressing Sintering