Abstract:Coal and biomass co-combustion in existing utility boilers is a promising option of mitigating the fossil energy crisis and reducing the gaseous emissions of NOx, SOx, and CO2. However, ash-related problems, including fouling, slagging, and corrosion cause damage to the heat exchange tube and reduce boiler efficiency. In an attempt to give better insights into the slagging behavior during coal/biomass combustion, an experimental investigation was conducted to study the growth of slag when coal was co-fired with wood and corn stalk in a 300 kW pilot-scale furnace. For comparison, combustion of pure coal was also conducted. During the experiments, biomass proportions of 5 and 10% by weight were examined. Slags formed on an oil cooled deposition probe were collected, sampled, and analyzed using scanning electron microscopy and X-ray diffraction (XRD). The change in slag thickness with time was obtained by a charge-coupled device monitoring system. With two thermocouples in the probe, the heat flux through the slag could be measured. The slag from pure coal combustion showed a layered structure with different levels of compactness and hardness. The heat flux decreased by 31.7% as the slag grew to 5.19 mm. The results showed that co-firing wood significantly inhibited the slagging behavior. Especially in the 10% wood case, hardly any slag was collected from the probe. Nevertheless, co-firing corn stalk resulted in severe slagging, with a slag thickness of 5.5 and 6.1 mm for two blend ratios. The formation of bubbles in the deposits together with greater deposit thickness caused heat transfer deterioration. XRD results revealed that the influence of co-firing biomass and corn stalk caused quite different changes to mineral species from wood. It was observed that fly ash under different biomass co-firing conditions differed little on mineral compositions.

Cause Analysis and Treatment Discussion on Slagging of 220MW Boiler

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Investigation of circumferential distribution of slag deposited on slag screen of Shell coal gasifier

Cause analysis and solutions about slagging of 670 t/h boiler in Zhuozi Power Plant

Solution to the Problems of Fire-Carrying in Primary Air Jet Orifice in 125MW Units

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Harmfulness and Preventing Measures of Slagging in Heated Surfaces of Boiler

Test Study Upon Slagging on the Heating Surface of Pulverized Coal Boiler

Investigation on Slagging Using Biased Secondary Air for Tangential Boiler

Experimental Study on Slagging Characteristic of Low-volatile Coal Water Slurry in a 220t/h Boiler

A MODEL FOR OVERALL SLAGGING DIAGNOSIS IN PULVERIZED-COAL FIRED BOILERS

Experimental Study on Slagging Monitoring of Pulverized Coal-Fired Boiler Based on Slagging Image

Theoretical and In-situ Experimental Investigation on Reducing Slagging Damage for Swirl-opposed Fired PC Boiler with Non-designed Blending Coals

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Research on the Dynamic Characteristic of Ash Deposition in Boilers Burning Coal and Coal Water Slurry

An Effective Strategy for Monitoring Slagging Location and Severity on the Waterwall Surface in Operation Coal-Fired Boilers

Slagging behavior and mechanism of high-sodium–chlorine coal combustion in a full-scale circulating fluidized bed boiler

Reason analysis and treatment for desulfurization slurry poisoning during combustion of Majialiang coal

SLAGGING ANALYSIS AND PREVENTION OF UTILITY BOILERS WITH TILTING BURNERS

Behavior of Slagging Deposits During Coal and Biomass Co-combustion in a 300 Kw Down-Fired Furnace

Study on the slagging trends of the pre-combustion chamber in industrial pulverized coal boiler under different excess air coefficients by CFD numerical simulation