Abstract:The elastic properties of 1D nanostructures such as nanowires are often measured experimentally through actuation of the nanowire at its resonance frequency, and then relating the resonance frequency to the elastic stiffness using elementary beam theory. In the present work, we utilize large scale molecular dynamics simulations to report a novel beat phenomenon in [110] oriented Ag nanowires. The beat phenomenon is found to arise from the asymmetry of the lattice spacing in the orthogonal elementary directions of the [110] nanowire,i.e., [-110] and [001] directions, which results in two different principal moments of inertia. Because of this, actuations imposed along any other direction are found to decompose into two orthogonal vibrational components based on the actuation angle relative to these two elementary directions, with this phenomenon being generalizable to <110> FCC nanowires of different materials (Cu, Au, Ni, Pd and Pt).The beat phenomenon is explained using a discrete moment of inertia model based on the hard sphere assumption, the model is utilized to show that surface effects enhance the beat phenomenon, while the effect is reduced with increasing nanowires cross-sectional size or aspect ratio.Most importantly, due to the existence of the beat phenomena, we demonstrate that in resonance experiments only a single frequency component is expected to be observed, particularly when the damping ratio is relatively large or very small.Furthermore, for a large range of actuation angles, the lower frequency is more likely to be detected than the higher one,which implies the experimental predictions of Young's modulus obtained from resonance may in fact be under predictions. The present study therefore has significant implications for experimental interpretations of Young's modulus as obtained via resonance testing.

Raman and AFM Characterization of Au and Cu Nanorod and Nanowire Arrays

Dynamically Regulated Ag Nanowire Arrays for Detecting Molecular Information of Substrate‐Induced Stretched Cell Growth

Beat Phenomena in Metal Nanowires, and Their Implications for Resonance-Based Elastic Property Measurements.

J212015 Quantitative Evaluation of Conductivity of Metallic Nanowires by Microwave Atomic Force Microscopy

Quantitative fitting of nonlinear current-voltage curves and parameter retrieval of semiconducting nanowire, nanotube and nanoribbon devices.

Study of the Raman-Afm System for Simultaneous Measurements of Raman Spectrum and Micro/Nano-Structures

Electronic properties of metal nanorods probed by surface-enhanced Raman spectroscopy

J212025 Fabrication of Nanowire Surface Fastener on Flexible Substrate and Its Electrical and Mechanical Properties

Non-contact Local Conductivity Measurement of Metallic Nanowires Based on Semi-Near-field Reflection of Microwave Atomic Force Microscopy

Synthesis and Raman Spectra of Si-Nanowires

G030084 Fabrication of High Density Cu Nanowire Array by Template Method and Its Evaluation

Optical Micro-Characterization of Single-Walled Carbon Nanotubes Extracted from AFI Crystals by Visible Emission and Raman Scattering

Application of Near-Field Raman Spectroscopy to Nano-Structure Characterization

Optical Properties and Surface Enhanced Raman Scattering of L-Shaped Silver Nanorod Arrays

Template synthesis, characterization and magnetic property of Fe nanowires-filled amorphous carbon nanotubes array

STRUCTURES AND PROPERTIES OF METALLIC NANOWIRES IN ATOMIC SCALE

Identification of the Structures of Superlong Oriented Single-Walled Carbon Nanotube Arrays by Electrodeposition of Metal and Raman Spectroscopy

The most powerful tool for the structural analysis of tungsten suboxide nanowires: Raman spectroscopy

Imaging the mechanical properties of nanowire arrays

High Surface-Enhanced Raman Scattering Activity from Au-decorated Individual and Branched Tin Oxide Nanowires

Au Nanoring Arrays As Surface Enhanced Raman Spectroscopy Substrate for Chemical Component Study of Individual Atmospheric Aerosol Particle.