Abstract:Different circumferential angle positions between stator or rotor vane rows in turbomachinery can lead to different flow structures or stage performances. The clocking effect phenomenon has been detected in axial compressor and turbine by investigators, but rarely reported on centrifugal compressor. The present work is an experimental investigation on the stator clocking effect between inlet guide vanes (IGV) and vaned diffuser in a low-speed centrifugal compressor. The experimental rig consists of a circumferentially rotatable IGV, an unshrouded centrifugal impeller, a vaned diffuser, a volute and etc. The impeller diameter is 796mm, and the rotate speed is about 3100 rpm. At each inlet prewhirl angle of -20 degrees, 0 degrees and +20 degrees, the stage performance curves are measured at three clocking angle positions of 0 degrees, 8 degrees and 16 degrees. The result shows that at the circumferential angles of 0 degrees and 8 degrees, the efficiency curve has a double peak value feature, but at the angle of 16 degrees being the conventional single peak value curve. Further, at the circumferential angles of 0 degrees and 8 degrees, the stage efficiency is bigger 3.6% than that case of the angle being 16 degrees, where the IGV prewhirl angles are 0 degrees and 20 degrees. When the IGV prewhirl angle is changed into -20 degrees, the stage efficiency increases about 2.0% near the first peak value position at the circumferential angles of Wand 8 degrees than at 16 degrees, however, at the second peak value position, the stage efficiency at the circumferential angle of 0 degrees is bigger about 1.4% than at 8 degrees and 16 degrees. Moreover, the circumferential angle positions between IGV and vaned diffuser have corresponding influence on the pressure ratio.

Experimental Study of the Clocking Effect of Straight and Bowed Stationary Blades in a Small Axial Clearance

NUMERICAL INVESTIGATION OF STATOR CLOCKING EFFECTS ON THE DOWNSTREAM STATOR IN A 1.5-STAGE AXIAL TURBINE

Experimental Study of Stator Clocking Effects in an Axial Compressor

Effect and Mechanism of Roughness on the Performance of a Five-Stage Axial Flow Compressor

Clocking Effect in a Two-Stage Compressor with Different Inter-Blade-row Gaps

Influence of Blade Lean Together with Blade Clocking on the Overall Aerodynamic Performance of a Multi-Stage Turbine

Numerical study on the clocking effect of a low-speed compressor with different inter-blade-row gaps

An experimental investigation of the vane clocking effects on the centrifugal compressor time-averaged performance

Numerical Simulation of Clocking Effect on Blade Unsteady Aerodynamic Force in Axial Turbine

Effect of Rotor CLOCKING on Blade Aerodynamic Load in Compressor Stages

Numerical Investigation of the Effect of Bowed Blade on the Performance of Transonic Axial Compressor

Numerical Simulation Of Clocking Effect On Wake Transportation And Interaction In A 1.5-Stage Axial Turbine

Numerical Study of Influence of Rotor Blades' CLOCKING Effect on Aerodynamic Performance of a Multistage Compressor

Investigation on Clocking Effect of 1.5-Stage Transonic Compressor

An Experimental Investigation On The Clocking Effect Between Inlet Guide Vanes And Vaned Diffuser In A Centrifugal Compressor Stage

Fully clocking effect in a two-stage compressor

Effect of clocking on unsteady rotor blade loading in a low-speed axial compressor at design and off-design operating conditions

Numerical simulation of clocking effect on turbine wake transportation process

CLOCKING EFFECT OF COMPRESSOR WITH DIFFERENT AXIAL GAPS PART-OVERALL PERFORMANCE

Unsteady Blade Loading with Clocking in Multistage Axial Compressors, Part 1

Some Effects of Non-Axisymmetric Tip Clearance Layout on Axial Compressor Aerodynamics